Multiquip MVH-150D2 manual Tellus #46 or equivalent, Grip to manuever the compactor

MVH-150D2 — COMPONENTS (PLATE COMPACTOR)

Figure 2. MVH-150D2 Components

Figure 2 shows the location of the controls, indicators and general maintenance parts. The function of each control is described below:

1.	Breather Cap – Remove this cap to bleed (remove air) the
	hydraulic system. When replacing hydraulic oil, use "Shell
	Tellus #46 or equivalent".
2.	Hand Grip – When operating the compactor use this hand
	grip to manuever the compactor.

3. Handle Lock – Pull handle bar downward (working position), then pull handle lock to lock handle bar in place.

4. Vibration Case Oil Level Check Plug – Remove this plug to check the vibration case oil. Oil level should be all the way up to the filler port. When replacing vibration case oil, use 10W-30 engine oil.

5. Handle Bar (working position) – When operating the compactor, this handle is to be in the downward position.

7. Engine – This plate compactor use a YANMAR L48V6 diesel engine. Refer to the owner’s manual for engine information and related topics.

8. Belt Cover – Remove this cover to gain access to the V- belts.NEVER run the compactor without the V-belt cover.If the V-belt cover is not installed, the possibility exist that your hand may get caught between the V-belt and clutch, thus causing serious injury and bodily harm.

9. Vibration Case – Encloses the eccentric, gears and counter weights.

10. Forward and Reverse Lever – Push the lever forward, the compactor will move in a forward direction, pull the lever backwards, the compactor will move in backwards direction. Placing the lever in the middle (midway) will cause the compactor not to move (neutral).

6. Handle Bar (stored position) – When the compactor is to be stored, move the handle bar to the upright position.

MVH-150D2 PLATE COMPACTOR — OPERATION AND PARTS MANUAL — REV. #2 (01/16/07) — PAGE 13