Chapter 1 Introduction
1-4. SAFETY AND NOTIFICATION
Following messages are safety reminders on how to protect your systems from damages. And thus, helps you lengthen the life cycle of the system.
1.Check the Line Voltage
a.The operating voltage for the power supply should cover the range of DC 16V~30V, otherwise the system may be damaged.
2.Environmental Conditions
a.Place your
b.Avoid extremely hot or cold places to install your PPC.
c.Avoid exposure to sunlight for a long period of time (for example in a closed car in summer time. Also avoid the system from any heating device.). Or do not use
d.Bear in mind that the operating ambient temperature is from 0°C up to +40°C.
e.Avoid moving the system rapidly from a hot place to a cold place or vice versa because condensation may come from inside of the system.
f.Place
g.Do not place the system too close to any radio active device. Radioactive device may cause interference.
3.Handling
a.Avoid putting heavy objects on top of the system.
b.Do not turn the system upside down. This may cause the floppy drive and hard drive to
c.Do not remove the diskette from the Floppy drive while the light is still on. If you remove the diskette while the light is on, you may damage the information on the diskette.
4.Good Care
a.When the outside of the case is stained, remove the stain with neutral washing agent with a dry cloth.
b.Never use strong agents such as benzene and thinner to clean the system.
c.If heavy stains are present, moisten a cloth with diluted neutral washing agent or with alcohol and then wipe thoroughly with a dry cloth.
d.If dust has been accumulated on the outside, remove it by using a special made vacuum cleaner for computers.
Page: |