Connecting to TV (cont’d)
Option 4 : Using Antenna jacks only
Antenna or | TV |
Satellite/Cable TV signal
12
3
E n g l i s h
Use this connection only if your TV set has a single Antenna In jack and does not have any audio/video jacks. For this type of connection, you need to set the channel of the TV set to follow that of the DVD recorder.
Have the following cable ready:
1)Antenna cable
1 Turn off your TV and remove the antenna cable from your TV (or Satellite Receiver/Cable Box.) Insert it to the ANTENNA input jack at the back of the DVD recorder.
2Use the supplied antenna cable to connect the DVD recorder’s TV output jack to the antenna input jack at the back of your TV set.
3Connect the power cable from the DVD recorder’s ~ MAINS to the power supply.
4Press
recorder to turn it on.
➜ The message 'IS THE TV ON?' appears on the display panel.
5Turn on the TV power. Select the correct Video In channel at the TV (see page 10.)
➜To switch between channel 3 and 4, hold down button {3} or {4} on the remote control to select the respective channel.
➜The first installation menu
{Language and Country } will appear on the TV.
6Proceed to page 24 to continue the first installation.
Helpful Hints:
–If the {LANGUAGE AND COUNTRY} menu does not appear, check the cable connections.
–To toggle between channel 3 and channel 4, you can press § button at the DVD recorder front panel while plug in the main cord of the DVD recorder to the power supply.
15
MRV660_17_Eng40 | 15 | 9/3/05, 10:24 AM | 3139 246 XXXXX |
|