Magnavox MRV660 user manual Connecting Additional Devices cont’d, Connecting a VCR/DVD player

Connecting Additional Devices (cont’d)

Connecting a VCR/DVD player

You will need this connection if you want to record the video tapes or discs to a DVD+R(W)s.

Option 1

1Use a component video cable (red/green/ blue) to connect the DVD recorder’s

COMPONENT VIDEO (IN-EXT1) input jacks to the corresponding component video output jacks on the VCR/DVD player.

2Use an audio cable (red/white) to connect the DVD recorder’s AUDIO L/R (IN-EXT1)input jacks to the audio output jack on the VCR/DVD player.

VCR/DVD player

Y

Pr

Pb

COMPONENT

VIDEO OUT

Before you start operating, press TUNER on the remote control, then press 3 4 to select ‘EXT1’ as the input channel. For recording, see pages 39~40.

Option 2

1Use a S-video cable to connect the DVD recorder’s S-VIDEO (Y/C) (IN-EXT2)input jack to the corresponding S-VHS output jack on the VCR/DVD player (as shown on the below illustration.)

OR

Use a video (CVBS) cable to connect the DVD recorder’s VIDEO (CVBS) (IN-EXT2)input jack to the corresponding video output jack on the VCR/DVD player.

2Use an audio cable (red/white) to connect the DVD recorder’s AUDIO L/R (IN-EXT2)input jacks to the audio output jack on the VCR/DVD player.

VCR/DVD player

Y

Pr

Pb

COMPONENT

VIDEO OUT

Before you start operating, press TUNER on the remote control, then press 3 4 to select ‘EXT 2’ as the input channel. For recording, see pages 39~40.

Helpful Hints:

–Most prerecorded video cassettes and

DVDs are copy-protected. If you try to copy them, the message 'COPY PRO' appears on the display panel.

–Connect the DVD recorder directly to the TV set. If there is a video recorder or an additional device in between, the picture quality may be poor because of the copy protection system built into the DVD recorder.

E n g l i s h

17

MRV660_17_Eng40 17 9/3/05, 10:24 AM 3139 246 XXXXX