JVC DR-M7S manual Set Stations a, Set Stations B, Fine-Tuning Channels Already Stored

Filename [DR-M7EK_11Subsidiary.fm]
DR-M7EK_01.book Page 99 Friday, April 2, 2004 11:21 AM	Masterpage:Right-No-Heading

99

Set Stations (A)

Set station names that are registered in your unit.

Perform steps A and B of “Manual Channel Set” on page 97 to access the Confirmation screen before continuing.

A Select the item.

Press rt w e to select the item you want.

B Access the Manual Channel Set screen.

Press ENTER twice.

C Select the new station.

APress rt to select “ID”, then press ENTER.

BPress rt until the new station’s name (ID) you want to store appears, then press ENTER. Registered station names ( pg. 100, “TV Station And ID List”) appear as you press rt.

Set Stations (B)

Set station names other than the ones registered in your unit.

Perform steps A and B of “Manual Channel Set” on page 97 to access the Confirmation screen and then perform steps A and B of “Set Stations (A)” ( pg. 99) before continuing.

A Select the character for station name.

APress rt to select “ID”, then press ENTER. B Press ENTER twice.

B Enter the new character.

APress w e to locate the character insertion point.

B Press rt to cycle through the characters (A–Z, 0–9,

–, f, +, I (space)) and stop when the desired character is indicated, then press e to enter.

C Enter the remaining characters the same way (maximum of 4).

D After entering all characters, press w e to select “OK”, then press ENTER.

D	Switch the stations.		C
				Close the Confirmation screen.
Press w e to select “OK”, then press ENTER.			Press SET UP twice.
● Repeat steps A – D as necessary.
		NOTE:
E Close the Confirmation screen.
			The characters available for the station name (ID) are A–Z, 0–9, –
			, f, +, I (space) (maximum of 4).
Press SET UP twice.
			Fine-Tuning Channels Already Stored
			Perform steps A and B of “Manual Channel Set” on page 97
			to access the Confirmation screen before continuing.
			A
				Select the channel to fine-tune.
			A Press rt w e to select the channel you want to fine-
			tune, then press ENTER.
			B Press ENTER twice.
			B
				Access the Manual Channel Set screen.
			Press ENTER. The Manual Channel Set screen appears.
			C
				Perform fine-tuning.
			A Press rt to select “FINE”.
			B Press w e until the picture appears in its best quality.
			● Repeat steps A – C as necessary.
			D
				Close the Confirmation screen.
			Press SET UP three times.

Page 99

April 2, 2004 11:21 am