JVC DR-M7S manual Set the input mode of recording deck, Start the source player

Filename [DR-M7EK_10Editing.fm]
DR-M7EK_01.book Page 81 Friday, April 2, 2004 11:21 AM	Masterpage:Right-No-Heading

81

Edit To Or From Another Recorder

You can use your unit as the source player or as the recording deck.

Slide the TV/CABLE/SAT/DVD switch to DVD.

A Make connections.

TV receiver
Player	Your unit
21-pin SCART cable
(provided)
21-pin SCART cable
(not provided)
Another recorder
Recorder
TV receiver
Recorder	Your unit
21-pin SCART
cable
(provided)
21-pin SCART cable
(not provided)
Another recorder
Player

Connect the player’s 21-pin SCART connector to the unit’s 21-pin SCART connector as illustrated.

AWhen using your unit as the source player:

— connect its L-1 IN/OUT connector to the recording deck.

BWhen using your unit as the recording deck:

— connect its L-1 IN/OUT or L-2 IN/DECODER

connector to the source player.

●If another recorder is compatible with the Y/C signal:

—when using your unit as the source player, set “L-1 OUTPUT” to “SCART S-VIDEO”. ( pg. 82, “L-1 Output and L-1 Input Setting (L-1 OUTPUT and L-1 INPUT)”)

—when using your unit as the recording deck, set “L-2 SELECT” to “S-VIDEO”. ( pg. 83, “L-2 Select Setting (L-2 SELECT)”)

B Set the input mode of recording deck.

With this unit, press PR +/– to select “L-1” for the L-1 IN/ OUT connector, or “L-2” for the L-2 IN/DECODER connector, depending on the connector being used.

●When using another recorder as the recording deck, refer to its instruction manual.

●When using the L-2 IN/DECODER connector, set “L-2 SELECT” to “VIDEO” or “S-VIDEO”. ( pg. 83, “L-2 Select Setting (L-2 SELECT)”)

C Set the recording speed.

Press REC MODE repeatedly until the desired recording speed appears.

D Start the source player.

Engage the Play mode of the source player.

E Start the recording deck.

Engage the Record mode of the recording deck.

F Stop dubbing.

Stop recording on the recording deck, then stop playback on the source player.

NOTES:

●All necessary cables can be obtained from your dealer.

●For Y/C signal input/output, be sure to use a 21-pin SCART cable that is compatible with the Y/C signal.

●When you use this unit as the source player for editing, be sure to set “SUPERIMPOSE” to “OFF” before starting. ( pg. 93)

●If you are using another recorder with S-Video and Audio output connectors, connect its S-Video and Audio output connectors to this unit’s S-VIDEO and AUDIO input connectors on the front panel. Then, set the unit’s input mode

to “F-1” in step B, and set “F-1 INPUT” to “S-VIDEO”. ( pg. 83, “F-1 Input Setting (F-1 INPUT)”)

Page 81

April 2, 2004 11:21 am