Fostex D1624, D824 Basic Locate function, Selecting the desired Program from multiple Programs

Page 23

D824/D1624 Quick Operation Guide

<Selecting the desired Program from multiple Programs>

If you have set up multiple Programs on the disk, you first need to select the target Program prior to recording, playback, or edit. To select a Program, follow the steps below. Do not select a different Program until you finish the session.

1.While this recorder is stopped, press the PGM key.

[Select PGM!] appears momentarily, then the number and title of the current Program appear.

2.Turn the JOG dial clockwise or counter-clockwise.

The numbers and titles of the Programs on the disk appear in turn.

3.Select the desired Program number and press the EXECUTE/YES key.

The top of the selected Program appears in ABS Time Base (ABS 0).

Basic Locate function

The Locate function enables you to locate the desired point (move the current position of the recorder) immediately. There are two locate methods: storing the desired locate point (time or bar/beat/clock value) into the memory keys, and locating the point without storing it.

This section explains “Locating the top of the Program” and “Locating the last recording point in the Program” and do not involve storing locate points. Refer to the Reference Manual for information on storing and locating locate points.

On this recorder, the top of the Program on the disk is called “ABS 0” and the end of the recorded area is called “REC END.” (If the Program has no data recorded, ABS 0 corresponds to REC END.) You can use this function to locate the ABS 0 or REC END point immediately, regardless of the current recorder position.

ABS 0

REC END

Recorded area

Locate ABS 0

Locate REC END

Current position

Locating the top of the Program

You can immediately move to the top of the Program (ABS 0), regardless of the current position of the Program.

1.Press and hold down the STOPbutton, and press the REWIND button.

1

Locating the end of the recorded area of the Program

You can immediately move to the end of the recorded area of the Program, regardless of the current position of the Program.

1.Hold down the STOPbutton and press the F FWD button.

1

23

Page 22 Page 24
Image 23
Page 22 Page 24
Contents About this manual Quick Operation GuideTrack Digital Recorder Safety Instructions Copyrights Recording mediaDamages Contents Recording media Package contentsDisassembling the removable case Preparation for the current driveAssembling the case Connecting cablesFixing the hard disk to the case Model 8551 Optional extension cable Installing the removable case in the recorderConnecting a detachable controller Press the EXECUTE/YES key again Turn the power onPress the EXECUTE/YES key Press the EXIT/NO key or the Stop button Press the EXECUTE/YES while holding down the Record buttonTime Base ProgramEXECUTE/YES key Setup of the Internal ClockPress the Setup key while in the stop mode Hints Connecting a analog mixerConnections when using the D824 Hints Connections when using the D1624Connections when using the D1624 Connecting a digital mixerAbout Sampling Frequency Initial settingsBasic recording Basic analog recording UNDO/REDO key Undo and redo recording single undo/redoAbout Digital In selection Basic digital recordingSelecting Digital Selecting Digital OutInt Auto Word Video Setting the reference clockAbout reference clock setting Ping-pong recording Multitrack recording using overdubbingRecording in a new Program MixdownLocating the end of the recorded area of the Program Basic Locate functionSelecting the desired Program from multiple Programs Locating the top of the ProgramVari-pitch function procedures Playback using the Vari-pitch functionReference pages PrecautionsSetup mode Reference manual refernece pagesAffect of Immunity on This Equipment Declaration of EC DirectiveFostex Distributors List In Europe Memo Fostex Corporation
Top Page Image Contents