Fostex D1624, D824 manual Connecting cables, Fixing the hard disk to the case, Assembling the case

Page 7

D824/D1624 Quick Operation Guide

Connecting cables

1.Connect the cables in the removable case to the connectors on the rear of the hard disk.

As shown in the figure, first connect the power supply cable. Make sure that you connect the cables securely in the correct direction.

<Note on the connectors>

Some connectors on the hard disks may be too tight to connect cables easily. Do not apply excessive force to such connectors to avoid injury or damage to the hard disk.

Fixing the hard disk to the case

1.Align the screw holes.

As shown in the figure, align the screw holes on the side of the disk with the holes on the case.

2.Insert four included fixing screws (two screws on each side) and tighten them.

Align the screw holes on the other side of the hard disk with the holes on the case.

Tighten four screws (two on each side).

<Note on tightening the screws>

Do not tighten the screws too much. Otherwise, you may damage the case.

Assembling the case

<Note>

When you assemble the case, follow the note below:

If a projecting part on the hard disk touches the cover, apply the insulation seal (included in the package) to the surface of the case where the part would touch. If you use the disk with its part touching the cover, a short-circuit may occur, leading to a malfunction.

1.Assemble the case by installing the covers.

After you assemble the case, store the case in a place not subject to magnetic fields. If you remove the case from the recorder and store or move the unit, cover the connectors on the removable case with the dust cover (included in the package) to protect the hard disk from building up static electricity and dust.

Do not touch the connectors with your fingers to avoid static electricity.

7

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Track Digital Recorder Quick Operation GuideAbout this manual Safety Instructions Damages Recording mediaCopyrights Contents Recording media Package contentsDisassembling the removable case Preparation for the current driveFixing the hard disk to the case Connecting cablesAssembling the case Connecting a detachable controller Installing the removable case in the recorderModel 8551 Optional extension cable Press the EXECUTE/YES key Turn the power onPress the EXECUTE/YES key again Press the EXIT/NO key or the Stop button Press the EXECUTE/YES while holding down the Record buttonTime Base ProgramPress the Setup key while in the stop mode Setup of the Internal ClockEXECUTE/YES key Connections when using the D824 Connecting a analog mixerHints Hints Connections when using the D1624Connections when using the D1624 Connecting a digital mixerBasic recording Initial settingsAbout Sampling Frequency Basic analog recording UNDO/REDO key Undo and redo recording single undo/redoAbout Digital In selection Basic digital recordingSelecting Digital Selecting Digital OutAbout reference clock setting Setting the reference clockInt Auto Word Video Ping-pong recording Multitrack recording using overdubbingRecording in a new Program MixdownLocating the end of the recorded area of the Program Basic Locate functionSelecting the desired Program from multiple Programs Locating the top of the ProgramVari-pitch function procedures Playback using the Vari-pitch functionReference pages PrecautionsSetup mode Reference manual refernece pagesFostex Distributors List In Europe Declaration of EC DirectiveAffect of Immunity on This Equipment Memo Fostex Corporation
Top Page Image Contents