Overview
Precautions
Handling the Unit
When shipping the unit
The original shipping carton and packing materials come in handy. For maximum protection,
When setting up the unit
The picture and sound of a nearby TV, VCR, or radio may be distorted during playback. In this case, position the unit away from the TV, VCR, or radio, or turn off the unit after removing the disc.
To keep the surface clean
Do not use volatile liquids, such as insecticide spray, near the unit. Do not leave rubber or plastic products in contact with the unit for a long period of time. They will leave marks on the surface.
Cleaning the Unit
To clean the cabinet
Use a soft, dry cloth. If the surfaces are extremely dirty, use a soft cloth lightly moistened with a mild detergent solution. Do not use strong solvents such as alcohol, benzine, or thinners, as these might damage the surface of the unit.
To obtain a clear picture
The HDD/DVD Recorder is a
Remote Control Operation Range
Caution
Do not mix old and new batteries. Never mix different types of batteries (standard, alkaline, etc.).
Notes on Discs
Handling Discs
Do not touch the
playback side of the disc. Hold the disc by
the edges so that
fingerprints will not get on the surface. Do not stick paper or tape on the disc.
Storing Discs
After playing, store the disc in its case.
Do not expose the disc to direct sunlight or sources of heat, or leave it in a parked car exposed to direct sunlight, as there may be a considerable temperature increase inside the car, which could distort the disc.
Cleaning Discs
Fingerprints and dust on the disc can cause poor picture quality and sound distortion. Before playing, clean the disc with a clean cloth. Wipe the disc from the centre outward.
Do not use strong solvents such as alcohol, benzine, thinners, commercially available cleaners, or anti-
static spray |
|
| |
intended for |
|
| |
older vinyl | Yes | No | |
records. | |||
|
|
Note on HDD
INTRODUCTION
Point the remote control at the remote sensor and press the buttons.
Distance: Within 23 ft (7 m) of the remote sensor.
Angle: Within 30° in each direction of the remote sensor.
Remote Control Battery Installation
Detach the battery cover on the rear of the remote control, and insert two AAA batteries. Make sure the polarities (+ and
•Do not move the recorder immediately after switching it off. Wait at least 2minutes after
•If the HDD/DVD Recorder is used improperly or in an unsuitable environment, it is possible that the HDD will fail.
•Power failure may cause data loss on the HDD.
•We recommend that you back up your important data to DVD discs in order to protect against accidental loss or possible HDD failure.
9