Daewoo DHR-9105P user manual Preferences / Auto Settings, Set Hdd Parental Lock, Auto Clock Set

DG-M32D1P-2A(GB) 2006.5.16 4:40 PM ˘ ` 28 mac001 1200DPI 100LPI

Setup menu

Set Hdd Parental Lock

It allows you to prevent from being played the title parental locked in HDD video menu. You can set the HDD parental lock as follow.

1 While ‘Preferences‘ is selected, press [ ] to select ‘Parental Controls‘. And press [ENTER].

PREFERENCES / Auto Settings

1 While ‘Preferences‘ is selected, press [ ] to select ‘Auto Settings‘.

2Press [ENTER] to display the submenu.

2Use [É/ ] to select ‘Set Hdd Parental Lock’ and press [ENTER]. The Password Input dialog will appear. Enter a 4-digit password using the [0-9] buttons. If this is the first time you have entered a password, you will be prompted to enter the password again to confirm it.

Parental Control

Set Parental Level	Adult
Change Password
Parental Country Code	AU
Set Hdd Parental Lock	Off

Select the parental lock

Off

Instructions: On

Enter-Confirm Setup-Exit Move É

3After setting the password, press [ENTER] while 'Set Hdd Parental Lock' is displayed.

4Enter your new password.

5Use [É/ ] to select the desired parental level and press [ENTER] to confirm.

Off : If you select Off, the Lock feature is not active. All titles in the HDD will play in full. On : If you select On, the Parental Lock feature is active in HDD Edit menu. To playback the title parental locked in HDD video menu, you must enter the 4-digit password. For detailed information, refer to page 50.

6Press [ENTER] to confirm your rating selection, then press [SETUP] to exit the menu.

Preferences

Video

Audio

Parental Controls

Auto Settings

Hard Disk

Instructions:

Enter-Confirm Setup-Exit

Move É

Auto Clock Set

Auto Clock enables the HDD/DVD Recorder to set the clock automatically whenever it is in Standby mode (plugged in but powered off).

Auto Clock is only available for models with the VPS/PDC function.

Some broadcasting stations may send the time and date along with the VPS/PDC data. The video will automatically use this time and date during the initial setting up procedure during normal use, and every time you switch the video off at the mains. If you find that this time and date is incorrect you can remove this feature by following the steps below changing it to the OFF mode, you will then have to manually set the time and date, see above.

1Use [É/ ] to select 'Auto Clock Set' and press [ENTER].

2Use [É/ ] to change the 'Auto Clock Set' status, and press [ENTER] to confirm.

Auto Settings

Auto Clock Set	On
VPS/PDC		Select	Auto
	On
		Clock Status
		Off
		On

Instructions:

Enter-Confirm Setup-Exit Move É

28