Glossary, Specifications 77
Glossary
AUDIO IN/OUT Jacks: jacks that receive audio from another source (IN) or send audio to another system (OUT).These jacks are red (right) and white (left).
Automatic Channel Setup: process in which the VCR memorizes TV channels.When you press SKIP i/CH
oor SKIP j/CH p in VCR mode, you only scan through TV channels you receive. Cable Box/DBS Output Channel: 03 or 04.
DIGITAL AUDIO OUT COAXIAL jack: Sends digital audio to a Stereo, letting you adjust the volume at the Stereo. This jack is black.
COMPONENT VIDEO OUT (Y, Pb/Cb, Pr/Cr) Jacks: jacks that send
Dolby® Digital: A surround sound system that provides 5.1 channel sound as used in movie theaters.
DTS: Digital Theater Systems.This is a surround sound system, but it is different from Dolby® Digital.The formats were developed by different companies.
HQ: high quality; a feature in the VCR circuitry which provides enhanced picture detail.
Line Input: The channel to which you set your System during video cassette copying. If you connected the other video equipment to the AUDIO and VIDEO In jacks on the front of the System, select L2. If you used the AUDIO and VIDEO IN jacks on the back of the System, select L1. If you accidentally enter Line Input mode, press SKIP i/CH o or SKIP j/CH p or the Number buttons to select another channel.
Tape Speeds: how fast the videotape travels during a recording or playback.The faster the tape speed, the better the picture quality. Slower tape speeds affect picture quality, but you record more onto a videotape.
• SP (standard play) – fastest tape speed (recording time for a T120 tape is approximately two hours); best picture quality.
• LP (long play) – average tape speed.You cannot record in LP with this VCR. If tapes were recorded on a
different VCR in LP speed, the tape will play in LP in the VCR of this System.
•SLP (super long play) – slowest tape speed (recording time for a T120 tape is approximately six hours).This speed allows the maximum recording on a single videotape.
VIDEO IN/OUT Jacks: jacks that receive video from another source (IN) or send video to other video equipment or a TV (OUT).These jacks are yellow.
Specifications
VCR Video Heads
Four heads -
Antenna
VHF/UHF - 75 ohm external antenna terminal
VHF Output Signal
Channel 03 or 04
75 ohms unbalanced
DVD Color System
NTSC
Amplifier
Output power (rms, 4 ohms, 1 kHz, 10% Total Harmonic Distortion) 300W total
-Front 50W/channel
-Center 50W
-Rear (Surround) 50W/channel
-Subwoofer 50W
FTC(Federal Trade Commission)
(4 ohms, 120 Hz to 12.5 kHz,
10 % Total Harmonic Distortion)
2 X 40W
Frequency Response
DVD (linear sound):
20 Hz to 22 kHz (sample rate: 48 kHz)
20 Hz to 44 kHz (surround off) (sample rate: 96 kHz)
Audio CD: 20 Hz to 20 kHz
Audio CD: 90 dB JEITIA
(Japan Electronics and Information
Technology Industries Association)
Dynamic Range
DVD (linear sound): 90 dB
Audio CD: 90 dB (JEITIA)
Total Distortion Factor
Audio CD: 0.01% (JEITIA)
DVD: 0.01%
Wow and Flutter
Below the measurement limitation (±0.001% W PEAK) (JEITIA)
Power Requirement
120V AC +/- 10%, 60 Hz +/- 0.5%
Power Consumption Power on: 120 W Power off (standby): 7.6 W
Operating Temperature 41°F (5°C) to 104°F (40°C)
Relative Humidity
30% to 80%
Dimensions (w x h x d) Receiver (System):
17” x 3.9” x 14.2”
43.5 x 9.9 x 36.2 cm
Front Speakers:
3.7” x 6.1” x 3.5”
9.4 x 15.5 x 8.8 cm
Rear Speakers:
3.7” x 6.1” x 3.5”
9.4 x 15.5 x 8.8 cm
Center Speaker: 9.8” x 3.7” x 3.5” 25 x 9.4 x 8.8 cm
Subwoofer:
7.9” x 12” x 13.6”
20 x 30.5 x 34.5 cm
Weight
16.1 lbs. (7.3 kg.)
NOTE: Designs and specifications are subject to change without notice.