Magnavox MDV 530 VR Safety and General Information, Safety Precautions, Declaration of Conformity

Page 3

Safety and General Information 3

Safety Precautions

Warning: To prevent fire or shock hazard, do not expose this equipment to rain or moisture.

Federal Communications Commission (FCC) Warning: Any unauthorized changes or modifications to this equipment void the user’s authority to operate it.

Department of Health and Human Services (DHHS) Certification: Complies with 21 Center for Radiation (CFR) chapter 1 subchapter J applicable at time of manufacture.

Laser Safety: This unit employs a laser. Only a qualified service person should remove the cover or attempt to service this device, due to possible eye injury.

CAUTION: USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF PROCE- DURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

CAUTION: VISIBLE AND INVISIBLE LASER RADIATION WHEN OPEN AND INTER- LOCK DEFEATED. DO NOT STARE INTO BEAM. THE BEAM IS LOCATED INSIDE, NEAR THE DECK MECHANISM.

Special Information for Canadian Users: This Class B digital apparatus

complies with Canadian ICES-003. Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.

Radio/TV Interference: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These lim- its are designed to provide reasonable protection against harmful interference in a residen- tial installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or televi- sion reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1) Reorient or relocate the receiving antenna.

2)Increase the separation between the equipment and the receiver.

3)Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

4)Consult the dealer or an experienced radio/TV technician for help.

Copyright Protection: Unauthorized copying, broadcasting, public performance and lending of Discs are prohibited. This product incorporates copyright protection technol- ogy that is protected by method claims of certain U.S. patents and other intellectual proper- ty rights owned by Macrovision Corporation and other rights owners. Use of this copyright protection technology must be authorized by Macrovision Corporation and is intended for home and other limited viewing uses only unless otherwise authorized by Macrovision Corporation. Reverse engineering or disassembly is prohibited.

Note to the Cable TV System Installer: This reminder is provided to call

the Cable TV system installer’s attention to Article 820-40 of the National Electrical Code, which provides guidelines for proper grounding – in particular, specifying that the cable ground shall be connected to the grounding system of the building, as close to the point of cable entry as possible.

Declaration of Conformity

Model Number:

MDV530VR

Trade Name:

Magnavox

Responsible Party:

Philips Consumer Electronics

 

P.O. Box 14810

 

Knoxville, TN 37914-1810

 

(865) 521-4316

Manufactured under license from Dolby Laboratories. "Dolby" and the double-D symbol are trademarks of Dolby Laboratories.

Copyright 2003 Magnavox. All rights reserved.

Page 2 Page 4
Image 3
Page 2 Page 4
Contents MDV530VR Dear Magnavox product owner For Customer UseModel No Serial No Safety and General Information Safety PrecautionsDeclaration of Conformity Table of Contents Introduction Color Systems Playable Discs and Video CassettesPlayable Discs Region CodesRemember HookupsDetermining the best possible connection Before you beginHookups cont’d Signal2DVD/VCR ConnectionsCable Signal RF coaxial cableChannel 03 or Video in Jacks On TV 2Audio Cables Video Cable DVD/VCR to a TV that has Component Video In jacks DVD/VCR to a TV that has an S-Video In jack Antenna/Cable TV SignalDVD/VCR to a TV and a Stereo 1Antenna/Cable TV SignalHookups cont’d Using Digital Audio connectionsRecycling Guidelines/Battery Safety Remote Control SetupPutting Batteries in the Remote Control Using the Remote ControlFirst-time DVD/VCR Setup Repeat this process if the power failsTurn on the TV Other tape playback features are on pages Video Cassette PlaybackDetails are on pages 4Insert a Disc Disc PlaybackPress OPEN/CLOSE a On the DVD/VCRSTANDBY-ON Light Display MessagesDisplay DVD Light red Disc trayCassette Compartment Timer REC LightDisplay Panel VCR Counter/Clock/ChannelFront Panel VCR Audio in Jacks AC Power CordANT-IN Antenna In Jack DVD Audio OUT Jacks Left white and Right redRemote Control Remote Control cont’d Now when you press Skip i/CHo or Skip j Channel SetupPress o or p to select Channel SET UP. Then, press B Press o or p to select Auto SET UP. Press BAdding/Deleting Channels Channel Setup cont’dDay appears. Then, press B Clock VCRFollow these steps to set the VCR clock. Make sure While the DAY space is flashing, press o or p untilClock VCR cont’d Press o or p to choose Language SELECT, then press B Press C-RESET/CLEAR to remove the menuPress o or p to select English Press C-RESET/CLEAR Language VCRVCR Status Displays Press Display again to remove all the displaysChannel numbers appear on Recording Prevention Videotape RecordingSelect the channel you want to watch at the TV Recording One Channel/Watching AnotherYou cannot pause an OTR One-Touch RecordingStopping an OTR Press Record on the DVD/VCRMake the connections shown above Rerecording Tape DuplicationPlaying unit To the TV’s Antenna in JackTimer Recording Timer Recording cont’d Details are on page nineEnter the information while the space is flashing Press o or p to select a recording tape speed. Cancelling Timer RecordingsDVD Put the DVD you want to copy in the disc tray DVD to Videotape DuplicationBe possible only if the DVD is not copy protected Before you beginRepeat Play Press o or p to select Auto RepeatPress B so on appears next to Auto Repeat Tape Counter Time Search, Index Search Time SearchIndex Search Viewing a Still Picture Special Effects PlaybackForward and Reverse Searching SP/LP/SLP Super High Speed Searching LP/SLPAutomatic Operation Features Understanding Displays Multi-Channel Television SoundPress DISC/MENU to remove the menu Multi-Channel Television Sound cont’dPlease see additional notes on Hi-Fi StereoPress o or p to select Audio OUT Then, press B Press o or p to select HIFI. on will appear besideUsing the Title Menu DVD Disc MenusPress TITLE. The Title menu will appear Fast Forward/Reverse Search During playback, press FF g or REW hPress Play B to return to normal playback Specific Time Playback Press DVD to put the DVD/VCR in DVD modeTitle/Chapter Playback, Specific Time Playback Specific Title/Chapter PlaybackTrack Playback BA,BPress DVD Paused and Step-by-Step Playback, ResumePaused and Step-by-Step Playback ResumeRepeat Repeat, A-B RepeatMarkers During playback, press Angle to select a different SubtitlesCamera Angles During playback, press Subtitle to select a subtiPress B to select CUSTOM, then press OK Parental Controls PasswordPress Setup Power failure will not erase your passwordPress o or p to select Parental LEVEL, then PasswordPress DVD to put the DVD/VCR in DVD mode. Press the Number buttons to enter your four-digitStereo Sound Mode Audio LanguageExample English audio DVD Slow Motion, Zoom Slow MotionZoom Programmed Playback You cannot alter a Program dur- ing playbackProgram can have a maximum of 99 Tracks Random screen appears While playback is stopped, press Mode twice soRandom Playback Red DVD light will appearJpeg Files have the icon 62 MP3/JPEG PlaybackOr OK To stop playback, press Stop CMP3/JPEG Displays Or, the following may appear to indicate Repeat playPress Display again to remove the display Press Or B to select display, then press OK When playback is stopped, press SETUP.Quick Setup screen will appear DisplayDisplay cont’d Press Setup to remove the menusLanguage Language cont’d Language CodesPress o or p to select a language, then press Audio While playback is stopped, press SETUP.On-Screen Displays Press Display repeatedly to see the following disPlays during DVD playback Virtual Surround Press DVD to put the DVD/VCR in DVD modeBlack Level, Virtual Surround Black LevelCare and Maintenance Cable Box/DBS Output Channel 03 or GlossarySpecifications Helpful Hints DVD/VCR has no powerRemote control will not operate the DVD/VCR There is no picture in DVD modeHelpful Hints cont’d Number buttons won’t work for TV channels above Power FailureVCR will not perform a timer recording VCR will not record a TV programYou cannot remove the tape Line Input modeCleaning the Video Heads You cannot insert a video cassetteMagnavox, P.O. Box 520890, Miami, FL 33152 402 Limited WarrantyPayment, if applicable Limited Warranty cont’dTo obtain a replacement product from Magnavox Exchange Fee + Sales Tax = TotalControls Information Index
Top Page Image Contents