JVC HR-XV32E manual 34 EN, VFP function Adjusting the picture quality

Filename [XV3EX_08DVD.fm]

XV3EX_01.book Page 34 Friday, August 22, 2003 12:21 PMMasterpage:Left+

34 EN OPERATIONS ON DVD DECK (cont.)

VFP function

— Adjusting the picture quality

The VFP (Video Fine Processor) function enables you to adjust the picture character according to the type of programming, picture tone or personal preference.

NOTE:

Before you start operation;

The VFP setting screen disappears if no operations are done for more than about 10 seconds. If the setting screen disappears before you finish, start from step 1 again.

1Access the VFP setting menu.

Press DVD PICTURE during

playback.NORMAL

● The current setting appears on	GAMMA	+0
	BRIGHTNESS +0
the TV screen.	CONTRAST	+0
	SATURATION	+0
	TINT	+0
	SHARPNESS	+3
	Y DELAY	+0

2Select the VFP mode.

Press w e repeatedly.

●Each time you press w e, the VFP mode changes as follows:

NORMAL]CINEMA]USER 1]USER 2](Back to the beginning)

NORMAL: Select this normally.

CINEMA: Suitable for movie.

USER 1/ You can adjust parameters that affect picture

USER 2: appearance and store settings. Go to step 3.

To adjust picture appearance manually

3Access the USER menu.

Press w e repeatedly to
select “USER 1” or “USER 2”.	USER 1

GAMMA +0

BRIGHTNESS +0

CONTRAST +0

SATURATION +0

TINT+0

SHARPNESS +3

Y DELAY +0

4Select the parameter.

Press rt repeatedly to select a parameter you want to adjust, then press OK.

●Adjust gradually and confirm picture appearance results are as preferred.

GAMMA	Controls brightness of neutral tints while
(–4 to +4):	maintaining brightness of dark and bright
	portions.
BRIGHTNESS	Controls screen brightness.
(–16 to +16):
CONTRAST	Controls screen contrast.
(–16 to +16):
SATURATION	Controls screen colour depth.
(–16 to +16):
TINT	Controls screen tint.
(–16 to +16):
SHARPNESS	Controls screen sharpness.
(+0 to +3):
Y DELAY	Controls screen colour gap.
(–2 to +2):

●VFP menu disappears and the following pop-up window appears on the TV screen.

GAMMA +0

GAMMA +0

5Adjust the parameter.

Press rt repeatedly to change the setting, then press

OK.

●The current VFP settings appear again.

6Adjust the other parameters.

Repeat steps 4 and 5 to adjust other parameters.

To return to the normal screen

Press DVD PICTURE.

To activate your setting

Press DVD PICTURE, then press w e repeatedly to select “USER 1” or “USER 2” that you have changed the parameters.

NOTE:

You cannot adjust the parameters of “NORMAL” and “CINEMA”.

Page 34

22 August 2003 12:20 pm