JVC HR-XV32E Video Recorder, Make connections, Engage the Record Pause mode of the recording deck

Filename [XV3EX_09Editing.fm]
XV3EX_01.book Page 55 Friday, August 22, 2003 12:21 PM			Masterpage:Right-No-Heading
			EN 55
Edit To Or From Another			B Select the VHS deck.
Video Recorder			Press VCR/DVD repeatedly so that the VCR indicator
			On the unit
You can use your unit as the source player or as the			lights up.
recording deck.			On the remote control
A When using your unit as the source player:			Press VCR so that the VCR indicator lights up.
TV	Player	Your unit	C Set the input mode of recording deck.
			With this unit, press AUX (number key “0”) and/or PR to
			select “L-1” for the L-1 IN/OUT connector, or “L-2” for
	AV mode		the L-2 IN/DECODER connector, depending on the
			connector being used.
	21-pin SCART cable
			● When using another recorder as the recording deck, refer to its
	(not provided)		instruction manual.
			● When using the L-2 IN/DECODER connector, set “L-2
			SELECT” to “A/V”. ( pg. 64)

	Another recorder
	Recorder
B When using your unit as the recording deck:
TV	Recorder	Your unit
	AV mode
	21-pin SCART cable
	(not provided)
	Another recorder

Player

Slide the TV/VCR/DVD switch to the right.

A Make connections.

Connect the player’s 21-pin SCART connector to the unit’s 21-pin SCART connector as illustrated.

AWhen using your unit as the source player:

— connect its L-1 IN/OUT connector to the recording

deck.

BWhen using your unit as the recording deck:

— connect its L-1 IN/OUT or L-2 IN/DECODER connector to the source player.

D Set the edit mode.

See “PICTURE CONTROL” on page 63.

E Engage the Record Pause mode of the recording deck.

Locate the point where you start recording, then engage the Record Pause mode.

F Start the source player.

Engage the Play mode of the source player.

G Start the recording deck.

Engage the Record mode of the recording deck.

NOTES:

●All necessary cables can be obtained from your dealer.

●When you select “EDIT” to dub tapes in step D, be sure to select “AUTO” (or “NORM” when “B.E.S.T.” is set to “OFF”) after you finish dubbing the tapes.

●When you use this unit as the source player for editing, be sure to set “O.S.D.” to “OFF” before starting. ( pg. 63)

Page 55

August 22, 2003 12:20 pm