Connections
Basic Connections
Antenna or Cable
Coaxial cable
Flat feeder
Matching transformer (not supplied)
AC Outlet | AUDIO | |
OUTPUT | ||
|
AC Power Cord | VIDEO OUTPUT |
Back of unit | VHF/UHF | |
| ||
| IN | |
Audio/video cable | VHF/UHF OUT | |
(not supplied) | ||
To Audio/video | RF cable | |
input connectors | ||
(supplied) | ||
|
To 75 ohm
Terminal
TV
~Place the unit on a stable, horizontal surface.
ŸConnect the unit to TV.
RF Connection
1Disconnect the TV antenna from the TV.
2Connect the TV antenna cable to the VHF/UHF
IN connector on the rear panel of the unit.
3Connect the supplied RF cable between the VHF/UHF OUT connector on the rear panel of the unit and the TV’s antenna terminal.
AV Connection
1Connect the antenna, unit and TV as per “RF
Connection.”
2Connect an optional audio/video cable between the AUDIO/VIDEO OUTPUT connectors on the rear panel of the unit and the TV’s audio/video
input connectors.
• Set your TV to AV mode.
!Plug the end of the AC power cord into an AC outlet.
This unit performs Plug&Play Set automatically. (☞ pg. 11)
The clock and tuner channels will automatically be set when the antenna is connected and when the AC power cord is connected to an AC outlet for the first time. (If “Auto” and the channel indicator are displayed on the front display panel before the unit is powered on, the clock and tuner channels are being set automatically. Wait for the time to be displayed on the front display panel before turning on the unit.)
⁄Set the VCR channel.
The VCR channel is the channel on which you can watch the picture from the unit on the TV only when using RF connection. With RF connection, set the VCR channel to “3 CH” or “4 CH.”
•The VCR channel is preset to “3 CH.” Set to “4 CH” if the Channel 3 is used for broadcasting in your area.
•With AV connection, set the VCR channel to “– CH” (off).
To set the VCR channel, perform the following steps:
Before performing the following steps:
•Make sure there is no cassette inserted in the unit.
•Make sure the unit is turned on, then press VCR/DVD on the unit so that the VHS indicator lights up on the front display panel.
1Press POWER on the unit to turn off the unit, then press 7 STOP on the unit for more than 5 seconds. “3 CH” appears on the front display panel.
2Press CH +/– on the unit to select “3 CH,” “4 CH,” or “– CH” (off), then press POWER on the unit.
Introduction
Preparation
Operations on VCR Deck
Operations on DVD Deck
Advanced Operations
Additional Information
9