JVC DR-MV5BE manual Playback DVD Deck, Initialising DVD Deck Only, General

Page 91

Filename [MV5S_13Subsidiary.fm]

 

MV5S_00.book Page 91 Wednesday, August 31, 2005 4:55 PM

Masterpage:Right0

 

TROUBLESHOOTING EN 91

Before requesting service for a problem, use this chart and see if

 

Playback (DVD Deck)

you can solve the trouble yourself. Small problems are often easily

 

 

solved, and this can save you the trouble of sending your unit off

 

 

 

The DVD deck cannot be operated.

for repair.

 

 

● The DVD deck is not selected.

Initialising (DVD Deck Only)

 

 

]Press VHS/DVD on the unit repeatedly or DVD on the remote

 

 

control so that the DVD lamp lights up on the unit.

Malfunction occurs on the unit.

 

 

 

Images do not appear on the TV screen.

]Press 1 to turn off the unit, press and hold 1, then press 8

 

 

● The TV receiver’s channel selector is not set to the AV mode.

for two seconds or more.

 

 

]Set the TV to its AV mode.

General

 

 

● When interlace scanned programme is played back, progressive

 

 

 

 

scan mode is selected.

 

 

]Press and hold PROGRESSIVE SCAN until disappears from

No power is supplied to the unit.

 

the front display panel. ( pg. 80)

 

 

●The AC power plug is disconnected from the AC outlet.

]Connect the AC power plug to the AC outlet securely. ( pg. 15)

 

Playback does not start or stop immediately after playback is

 

 

started by pressing

.

The disc tray cannot be opened.

 

On the front display

panel, “NO DISC” appears.

]Open the disc tray by following the steps below.

 

● The disc is loaded upside down.

1. Press 8 and 1 on the unit simultaneously.

 

]Place the disc on the disc tray with the playback surface facing

2. Press and hold x (OPEN/CLOSE) on the unit for

 

down. ( pg. 9)

approximately 30 seconds until the tray is opened.

 

● A disc not being compatible with the unit is loaded.

3. Remove the disc, then press x (OPEN/CLOSE). The unit

 

]Load a playable disc on the unit. ( pg. 6)

shuts off.

 

● A dirty disc is loaded.

 

 

]Clean the disc. ( pg. 9)

The remote control does not work properly.

 

● Defective disc is loaded.

 

 

]Remove the batteries, wait for 5 minutes or more, then load the

 

]Replace the warped or scratched disc with a normal one.

batteries again.

 

 

 

 

Images are blurred or distorted when you start High-Speed

● The setting of the remote control code is inappropriate.

 

 

Search.

]Set the same remote control code (1, 2, 3, or 4) on both the unit

 

 

]Images are blurred or distorted at the point where the playback

and the remote control. ( pg. 74)

 

● The batteries are discharged.

 

speed changes and this is not a malfunction of the unit.

]Replace the dead batteries with new ones.

 

 

 

 

Playback does not start.

 

 

 

 

 

 

Dubbing from the external equipment is not possible.

 

]Playback does not start for approximately 30 seconds after

● The source (another video recorder, camcorder) has not been

 

recording is stopped and this is not a malfunction of the unit.

properly connected.

 

 

 

]Confirm that the source is properly connected.

 

 

 

●All necessary power switches have not been turned on. ]Confirm that all units’ power switches are turned on.

●The setting of the input channel position is inappropriate. ]Select the input channel position (“F-1”, “L-1” or “L-2”) that

corresponds to the input terminal connected to the external equipment. ( pg. 43)

The on-screen display superimposed on the programme played back/received on this unit is recorded when you dub the programme to an external recording equipment.

]Set “SUPERIMPOSE” to “OFF”. ( pg. 79)

The unit does not operate.

●There are cases when the operation is prohibited on the disc.

●Lightning or static electricity may cause malfunction of the unit. ]Press 1 to turn the power off, then press the button again to

turn the power on.

The remote control of a JVC TV will not operate the unit.

●The setting of the remote control code is inappropriate. ]To operate the unit using a JVC TV remote control, set the

remote control code of the unit to “1” (Default: “3”). ( pg. 74)

Page 91Wednesday, 31 August 2005 16:55

Page 90 Page 92
Image 91
Page 90 Page 92
Contents DR-MV5SE DR-MV5BE Mains outlet Filename MV5S02Safety.fmTo mobile phone users For ItalyDo not place the unit Do not block the unit’s ventilation openings or holesEnjoy the vivid picture quality DVD recording/playback Filename MV5S03Contents.fmMasterpageRight0 Contents DVD-RAM Discs About DiscsRecordable/Playable Discs Discs For Playback OnlyRegion Number Recording Medium And FormatUnplayable Discs File Structure Of DiscsMarks related to video DVD Video MarksAudio CD/Video CD/Super Video CD Svcd JPEG/MP3 Disc CD-R/RW/ROMCare And Handling Of Discs Placing a DiscRear View Front ViewFilename MV5S05Name.fm How To Use Remote Control pg On-Screen Display DVD deck Cassette Loaded Mark On-Screen Display VHS deckC D EFG H I J K L M N Front Display PanelComposite Connection ConnectionsLuminance brightness Component Video Connection DVD deck only VHS DVD Auto Set UpSET UP Number SetClock Set/Auto Guide Program Number Set Preset DownloadLink Functions DVD Deck Only On The Front Display PanelVHS LanguagePan&Scan VHS DVD Enter SET UPMonitor Set DVD Deck Only Pan&Scan/Letter BoxFilename MV5S06TocOperation.fm About recording modeWant to do? Filename MV5S07Basic PlayRec.fm Basic Playback DVDTo play back an MP3/JPEG disc, see Playback With MP3 Usable cassettes Basic Playback VHSCompact VHS camcorder recordings can be played on this Load a recordable disc Basic Recording DVDRecording Recording amount Recording ModeMode Approx Time approx Recording Resume FunctionBasic Recording VHS Maximum Recording Use Mode Time ApproxClear VHS DVD Cancel Showview Timer Enter ReturnSatellite Receiver Users DVD Deck Only VPS/PDC Recording Weekly/Daily RecordingDVD Timer Manual Timer ProgrammingFor DVD deck Satellite Receiver Users On-Disc Timer Programming DVD DeckTo Make The Disc For On-Disc Timer Programming OnlyHow Discs Are Overwritten Rtwe Check, Cancel And Change ProgrammesTo cancel the programme SATTo change the programme setting When Programmes Overlap Each OtherCancel Prog Enter Press CancelRecording DVD Deck Only REC ModeSAT Auto Title Creation Dubbing Auto Recording Mode OptimizerStop and pause mode on the DVD deck To DVDVHS/DVD VHS Dubbing Dubbing a Part Of a CassetteDubbing An Entire Disc REC Mode Progressive ScanVHS/DVD Dubbing Dubbing a Part Of a Disc Enter REC ModePR + DV Dubbing DVD Deck Only Performing dubbing without using the DV Dubbing controllerEdit From a Camcorder If the camcorder has no S-VIDEO output connectorPanel When using your unit as the recording deck When using your unit as the source playerOutput/Input Set Output And L-1 Input SettingInput Setting Select SettingExample Dubbing to an MD Digital Audio DubbingHigh-Speed Search Advanced Playback DVDDVD TOP Menu Enter Skip Search Resume FunctionStill Picture/Frame-By-Frame Playback Slow MotionSubtitle Selection Checking The Time Information Angle SelectionYour desired audio language Sound Audio Channel SelectionSelection display appears Press Audio or w e to selectDisplay Recording/Playback Status DisplayRecording screen Overview Of Live Memory PlaybackDisplay During Live Memory Playback To Watch a Programme Previously Recorded While Recording Available only when pausedButtons To Be Used During Live Memory Playback Enter Navigation Using The On-screen BarHow To Access The On-screen Bar Basic Operation On The On-screen BarLocating The Beginning Of a Desired Selection Repeat PlaybackEnter On Screen Clear To select track 5, press the number button Adjusting The Picture QualitySetting The Progressive Mode Time SearchProgramme Playback Select The Switching Interval Of The Slide ShowCancel Enter Random PlaybackIndex Search Clean the video heads using a dry cleaning cassette whenAdvanced Playback VHS Quick Rewind a LittleSoundtrack Selection Next Function MemoryManual Tracking VHS Progressive ScanDVD TV/VIDEO Instant Timer Recording ITRAdvanced Recording DVD Elapsed Recording Time And Disc Remaining Time IndicationFree Rate Function Select FR Just in a recording mode selection procedureSelection Of The Audio Channel To Be Recorded On a Disc Accidental erasure prevention Advanced Recording VHSElapsed Recording Time Indication 0000Playback Tape Remaining TimeTo Record Stereo and Bilingual Programmes A2 To Record Nicam Stereo and Bilingual ProgrammesDisplay for original Display for play list Recording Library Database DVD NaviIcons and their meanings Modify Index Scan For Beginning Of TitleMemo Enter Navigation Modify Category Delete Unwanted Part Of The Title DVD-RAM/DVD- RW VR modeProtect Title DVD-RAM/DVD-RW VR mode Modify Title NameMemo Modify Play List InformationAdd Scenes To a Play List Create Play ListSCENE, then press Enter Move ScenesPress 8 to stop playback Play Back Play ListDelete Play List Modify Play List NameDelete Information Modify Library InformationScan For Title From Library Register DiscOn completion of the playback of all the items Locating The Desired Group And TracksFor MP3 Playback For Jpeg PlaybackFor DVD operations For VHS operations Format Remote control settingTips for your trouble Specifications For better soundRemote Control 1/2/3/4 Code Switching Remote Control FunctionsEnter SET UP Brand Name Code TV Multi-Brand Remote ControlPerfect Connections Recommended Has two 21-pin AV input Scart connectorsPin AV input Scart connector IN/DECODER connector to the satellite receiver’s connectorWhen you can’t switch the audio channel of a bilingual Connecting/Using a Decoder DVD Deck OnlyProgramme DVD Digital Audio OUT Dolby Digital / PCM / Stream Mode Set DVD DeckRecording SET PAL To record PAL signals Secam To record Secam signalsOFF You cannot use the resume function Scan Mode SetVHS Enter Mode Set VHS DeckThen press Enter Press rt to select the desired To unlock tray Tray Lock DVD Deck OnlyFor Example To lock trayGuide Program Number Set Showviewtm System SetupGuide Program Number Language of your choice Tuner SetAuto Channel Set Vacant channels Press rt w e to select yourPress rt to input the channel Press SET UP to close the Confirmation screenNumber you want to store Change Station Channel Position Cancel Enter SET UPPress SET UP twice to close the Confirmation screen Delete a ChannelSet Stations B When Receiving a Scrambled Broadcast DVD Deck OnlyFine-Tuning Channels Already Stored Set Stations aJust Clock Press SET UP to start the clock operationClock Set Press w e to select ClockThen press t Format a Disc DVD Deck OnlyFormat a DVD-RAM Disc Format a DVD-RW DiscDVD Enter Cancel The Finalisation Of a DVD-RW DiscAfter finalising For DVD-R/RW Video mode discs Finalise a DVD-R/RW DiscInitialising DVD Deck Only Playback DVD DeckGeneral Recording VHS Deck Timer Recording DVD DeckPlayback VHS Deck Recording DVD DeckFor component video connection Timer Recording VHS DeckOther Problems For composite connectionAn invalid Showview number has been input.  pg Timer recording has finished during Live Memory playbackDuring Live Memory playback, 8 has been pressed.  pg Dimensions WxHxD Power requirementPower consumption TemperatureLanguage Code List TV Station And ID List Elapsed Recording Time Indication Select The Switching Interval Of The Slide ShowWhen Programmes Overlap Each Other Audio Language/Sound SelectionMemo EN 100Wednesday, 31 August 2005 Filename MV5S15Cov4.fm

DR-MV5BE specifications

The JVC DR-MV5BE is a versatile and feature-rich DVD recorder and VCR combo that caters to the needs of users looking to digitize their home video collection while enjoying the convenience of a dual-format device. This innovative unit combines both DVD recording and VHS playback capabilities, making it a valuable addition to any home entertainment setup.

At the core of the JVC DR-MV5BE’s functionality is its ability to record directly onto DVD discs, offering several formats including DVD-R, DVD-RW, and DVD+R. This flexibility allows users to choose the best format suited for their recording needs, whether they prioritize compatibility with other devices or rewritable options. The device also supports various recording modes, from high-quality SP mode to extended recording modes like LP and EP, granting users control over recording time and quality.

The integrated VHS player adds to the DR-MV5BE’s appeal, allowing users to play their existing VHS tapes seamlessly. This feature is perfect for those looking to preserve old home movies, as the unit can convert VHS content to DVD format through a simple dubbing process. Additionally, the DR-MV5BE features front and rear audio/video inputs, enabling users to easily connect camcorders, gaming consoles, or other external devices for recording or playback.

In terms of connectivity, the JVC DR-MV5BE is equipped with various options. The HDMI output ensures high-definition video playback, while the standard composite outputs allow compatibility with older televisions. The presence of a USB port provides further versatility, allowing users to record or transfer content to and from USB storage devices.

The unit also boasts a user-friendly interface and remote control, simplifying the recording and playback process. With built-in features such as a programmable timer, users can schedule recordings in advance, ensuring they never miss their favorite shows or events.

Overall, the JVC DR-MV5BE is a robust device that encapsulates modern recording technology while retaining the nostalgia of VHS. Its blend of functions, alongside its user-friendly design and versatility, makes it a standout option for anyone looking to bridge the gap between analog and digital media.
Top Page Image Contents