Installation and Operation, cont’d
7. Assemble the
a. Pass the legs of the
b. Place the legs around the projector pole.
c. Pass the legs through the holes in the contour base.
NThe pole fits snugly into the depression in the center of the contoured base.
d. Pass the legs through the holes in the L-shaped bracket.
NThe supplied
Mount Plate
Flange
| Contoured |
| Base |
| |
| |
| Bracket |
Slotted Hole |
|
in PMK Tray | |
| Bracket Screws |
Ceiling
Pole
Figure 2-8 — Hanging the PMK 350 tray on the projector pole
8. Align the two holes in the bottom of the
with the two holes in the base of the tray. Secure the
9. Move the PMK 350 up to the desired location on the ceiling pole, as close to the ceiling as desired.
10. Secure the
NBe sure to tighten the hex nuts securely enough that the PMK 350 does not slide down the ceiling pole. A socket wrench is recommended to tighten the hex nuts.
11. Secure the front and rear plates to the mounting tray with four of the included #6 screws.
12. If desired, choose one of the provided four sizes of self- adhesive cover sheets, and apply it to the underside of the mounting tray.
Front and Back Panel Features and Connections
2
|
| |
| 1 |
|
|
| DVI DL 101 |
| POWER | DVI DL 101 |
| ||
| 12V | |
| 0.2A MAX |
|
| 4 |
|
|
| 3 |
| DVI DL front and rear panels | |
A | Status LED — This | |
| DVI DL is receiving power. When a DVI input signal is present, | |
| this LED lights green. |
|
B | DVI input connector — Plug the cable from the input source | |
| device into this dual link female |
rates of up to 2560x1600 @ 60 Hz and single link rates of up to 1920x1200 and 1080p @ 60 Hz are supported. The table on the next page shows the DVI pin configuration.
NDual link DVI cables must be used for dual link DVI signals. If a single link DVI cable is used, only single link DVI signals are possible.
DVI DL 101 • Installation and Operation |