GoVideo DV2140 manual Operation with tape Normal Playback, Special Effect Playbacks

Page 21

Operation with tape

Normal Playback

Preparation:

Turn on the TV.

Tune the TV to the DVD+VCR output channel (CH 3 or 4) or set the TV’s source selector to VIDEO.

If a direct VIDEO/AUDIO connection is made between the DVD+VCR and the TV, set the TV’s source selector to VIDEO. Set the Output Source to VCR as shown in “Setting the Output Source” on page 6.

1

Insert a prerecorded video cassette.

The

indicator will light and the DVD+VCR will

power-up automatically.

Make sure that the indicator in the display window is not lighted. If it is, press POWER once. If a tape without a safety tab is inserted, the unit will start playback automatically.

Press PLAY ( N ) once.

2 PLAY appears on the TV screen .

It is not necessary to select the tape speed for play- back. It will be automatically selected by the DVD+VCR. During playback, the TV/VCR selector switches to VCR mode automatically.

3STOP appears on the TV screen.Press STOP (x) to stop playback.

If the tape reaches the end before STOP (x) is pressed, the DVD+VCR will automatically stop, rewind, eject, and will turn itself off (Only when no disc).

Tracking Control

Auto Tracking

The automatic tracking function adjusts the picture to remove snow or streaks.

The AUTO TRACKING function works in the following cases:

A tape is played back for the first time.

Tape speed (SP, LP, SLP) changes.

Streaks or snow appear because of scratches on the tape.

Manual Tracking

If noise appears on the screen during playback, press either TRK(+/-)on the remote control or

CH (V/v) on the front panel until the noise on the screen is reduced.

In case of vertical tremble, adjust these controls very carefully. Tracking is automatically reset to normal when the tape is ejected or the power cord is unplugged for more than 3 sec- onds.

Special Effect Playbacks

Special effects playback notes

Horizontal lines (noise bars) will appear on the TV screen. This is normal.

The audio is automatically muted during special effect modes, so there is no sound during search.

During the high-speed picture search modes, a short period is needed to stabilize tape speed when re-entering the PLAY mode. Slight interference may be observed during this period.

Search

This function lets you search for a desired tape section in either direction: forward or reverse quickly and visual- ly.

1Press BACKWARD (.) or FORWARD (>) during playback.

The DVD+VCR will be activated in the SEARCH mode.

If the DVD+VCR is left in the SEARCH mode for more than 3 minutes, the DVD+VCR will automatically enter the PLAY mode, to protect the tape and video heads.

2To return to playback, press PLAY ( N ).

Still Picture and Frame-by-Frame Playback

1Press PAUSE/STEP (X) during playback. Still picture will appear on the TV screen.

If a still picture vibrates vertically, stabilize it by pressing TRK(+/-)on the remote control.

If the DVD+VCR is left in the STILL mode for more than 5 minutes, the DVD+VCR will automatically enter the STOP mode to protect the tape and video heads.

2Press PAUSE/STEP (X) repeatedly to advance the video picture one frame at a time while viewing a still picture.

3To return to playback, press PLAY ( N ).

Slow Motion

1During the still mode, press FORWARD (>). The tape will be played back at a speed 1/19 times slower than the normal speed.

During slow playback, use TRK(+/-) on the Remote Control to minimize noise bands.

If slow motion mode continues for more than 3 minutes, the DVD+VCR will automatically change to playback mode.

2To return to playback, press PLAY ( N ).

Commercial Skip

This is useful for skipping commercials or short program segments.

1Press SKIP during playback mode.

The tape will be fast forward picture search through 30 seconds of recording.

The skipping time can be extended by pressing SKIP. Subsequent presses result in advancing the fast forward picture search time by 30-second increments (maximum 3 minutes).

2When the search is completed, the DVD+VCR will go into playback mode automatically.

OPERATION

21

Image 21
Contents Page Safety Precautions Otes on CopyrightsRegulatory Information FCC Part Introduction Important Safety InstructionsTable of Contents Remote Control Operation Range Remote control battery installationBefore Use Playable DiscsPrecautions About SymbolsSetting the Output Source Front Panel Display Window DVDREC Remote Control Video OUT DVD OUT Rear PanelDigital Audio OUT Coaxial DVD OUT ANT.IN Antenna InputConnecting Antenna/Cable TV to ConnectionsPreparation Optional, Preferred TV Connections Connections Basic TV ConnectionsDigital Multi-channel sound Accessory Audio/Video A/V Connections toRear of DVD+VCR Ote A1A2VCR Operation Setup On-Screen Display OSD Setting the On-Screen DisplayMenu Selection Channel Selection VCR Operation Setup Setting the VCR Setup MenuVCR Operation Setup Setting the Clock Auto Clock SetManual Clock Set General Explanation DVD Operation SetupOn-Screen Display On-screen display operationInitial Settings General Operation DVD Operation Setup Initial SettingsLanguage DisplayOthers AudioLock Operation with tape Normal Playback Special Effect PlaybacksOperation Operation with tape Normal Recording Timer RecordingTo pause the recording To record one TV program while watching anotherOperation with tape Checking Erasing the Timer ProgramProgram Priority Same day, priority is given to Earliest recording. ForInstant Timer Recording Checking the Recording TimeTo extend the Recording Time MTS Multi-Channel TV Sound Multichannel TV Sound Indicator MTSSAP Second Audio Program Recording TV screenAdditional Information VCR Operation with tape Tape Counter Memory FeatureOperation with DVD Playing DVD General FeaturesOperation with DVD General Features Additional Information DVD Operation with DVDAbout MP3 About WMA Windows Media AudioTo stop playback at any other time Press Stop Moving to another Track CD MP3 Operation with Audio CD and MP3/WMA DiscsRepeat Track/All/Off CD MP3 WMA Repeat A-B CDMoving to Another File Operation with Photo Disc Viewing a Photo Disc JpegTo Rotate picture Insert a disc and close the trayRepeat Programmed Tracks Programmed Playback CD MP3Erasing a Track from Program List Erasing the Complete Program ListSymptom Cause Correction TroubleshootingDVD+VCR is in Timer mode ReferenceMoisture Condensation Troubleshooting Video Head Cleaning Video head cleaningVideo head clogging Language Code Language Code ListCountry Code Country Code ListVCR Specifications SpecificationsDVD Specifications General3834RV0009B