Technics PV-D4754S manual Review, Replace or Clear Program Contents

*Important: If a remote control button does not work when pressed, press the VCR button on the remote and try the button again.

Review, Replace or Clear Program Contents:

(Recording is not in progress)

1Press PROG

to display Program List.

2		P DT START				STOP	CH	SPD	Press
	1 13			2:00p		3:20p	02	SLP	to select number.
	3		-- --	:	--	--:--	--10	--
	2 14			7:00p		7:30p		SP
	4		-- --	:	--	--:--	--	--
		CANCEL			: ADD/DLT
		SELECT			:	SET : SET
		EXIT			: PROG
3 To Replace program...
		P DT START				STOP	CH	SPD	Repeat Step 2 (p. 24)
		1 13		2:00p		3:20p	02	SLP	to set new programs.
		2 14		7:00p		7:30p	10	SP
	3		-- --	:--		--:--	--	--
	4		-- --	:--		--:--	--	--
		SELECT			:	SET : SET
		EXIT			: PROG
					or
	To Clear program								...
		P DT START				STOP	CH	SPD	Press ADD/DLT.
		1	-- -- --			-- --:	--	--
		2	14	7:00p		7:30p	10	SP
	3		-- --	:--		--:--	--	--
	4		-- --	:--		--:--	--	--
		SELECT			:	SET : SET
		EXIT			: PROG

To cancel a Timer

Recording in progress...

Hold down STOP in VCR mode for a few seconds to cancel the Timer Recording.

(The “TIMER” Indicator goes out on Multi Function Display.)

•Any future daily or weekly recording will be performed as programmed.

VCR

Operation

4Press PROG

to end the programming.

Notes

•If you are using a Cable Box, the VCR’s channel for Timer Recording must be set to the Cable Box input channel and Cable Box must be manually set to the desired channel. Cable Box power must be left on.

•2 minutes before Timer Recording is performed, “PLEASE PREPARE FOR TIMER REC” appears and Timer Indicator flashes.

Be sure a cassette with record tab is loaded and DECK is in Stop mode.

•If a power interruption occurs while programming the timer, the timer program(s) may be canceled. If “TIMER PROGRAMS WERE LOST DUE TO POWER INTERRUPTION” appears on-screen, please re-enter the timer programs.

•If the start time for Timer Recording comes up during recording and playing back, Timer Recording will not be performed.

Important notes when using DSS Receiver

•When recording programs via DSS Receiver, DSS Receiver must be left on.

•When recording programs via an antenna or cable, DSS Receiver must be turned off.

25