SIIG L732, L704, L733, L734 Hardware Kit, Installation And Operating Instructions

Page 2
INSTALLATION AND OPERATING INSTRUCTIONS

INSTALLATION AND OPERATING INSTRUCTIONS

Caution

Prior to the installation of this product, the installation instructions should be read and completely understood. The installation instructions must be read to prevent personal injury and property damage. Keep these installation instructions in an easily accessible location for future reference.

CAUTION: The maximum load capacity is 121 lbs. Use with products exceeding the maximum load capacity may cause serious injury. See apparatus instructions.

Recommended mounting surfaces: wood stud and solid-flat concrete. If the mount is to be installed on any surface other than wood studs or concrete, use suitable hardware (not included but commercially available).

Do not install on a structure that is prone to vibration, movement or chance of impact. Failure to do so could result in damage to the display and/or damage to the mounting surface.

Do not install near heater, fireplace, air conditioning, in direct sunlight, or any other heat producing source. Failure to do so may result in damage to the display and could increase the risk of fire.

The wall structure must be capable of supporting at least the maximum load capacity as indicated. If not, the wall must be reinforced. Proper installation procedure by yourself or a qualified service technician, as outlined in the installation instructions, must be adhered to. Failure to do so could result in serious personal injury.

When mounting to a wall that contains wood studs, confirm dead center of the wood stud prior to installation, it is recommended that the wood studs be a minimum of 16" apart.

It is recommended that two people perform the installation. Injury and/or damage can result from dropping or mishandling the display.

Hardware Kit

A

(×4) M5×16 screw

G

(×4) M6 washer

 

 

 

 

B

(×4) M6×16 screw

H-1

(x4) M5 washer

 

 

 

 

C

(×4) M8×16 screw

H-2

(×1) Bubble level

 

 

 

 

D

(×4) M5×35 screw

I

(×4) M8×80 bolt

 

 

 

 

E

(×4) M6×35 screw

J

(×4) Concrete anchor

 

 

 

 

F

(×4) M8×35 screw

K

(×4) M8 spacer

 

 

 

 

 

 

L

(x2) Sponge sticker

 

 

 

 

2

Image 2
Contents Ultra-Thin LED/LCD TV Mount - 32 to Max load capacity 121lbs/55kgInstallation Instructions Hardware Kit INSTALLATION AND OPERATING INSTRUCTIONSStep 1 Wall Plate Installation a Wood Stud Installation Tools Requiredb Concrete/Brick Installation NOTE The concrete anchors must be used for concrete installationStep 2 Display Bracket Installation Check the mounting screws every two months for tightness Step 3 Final Installation & AdjustmentMaintenance Technical Support and Warranty Copyright 2010 by SIIG, Inc. All rights reserved About SIIG, IncNovember