InstallationTo reduce the risk of injury, follow the Pressure
Relief Procedure in your Pro Xp manual before
installing this kit.
1. Relieve the pressure.
2. Remove the retaining ring, air cap/tip guard, and
spray tip.
3. Flush the gun as instructed in your gun manual.
Relieve the pressure.
NOTICE
Do not operate the gun with a damaged
electrode (4a). Make sure the electrode is in
place before installing the air cap/electrode
assembly (4).
NOTE: The kit includes a large retainer (2) for
a larger pattern, and a small retainer (3) for a
smaller pattern.
4. Check that the electrode (4a) is in place in the air
cap. The two ends of the electrode should be
inserted in the two holes on the back of the air
cap, and should protrude throughthe front of the
air cap. Install the diffuser/seal assembly (1), air
cap/electrode assembly (4), and desiredretainer
(2 or 3) onto the gun. Tighten the retainer firmly.