Installation
NOTE: All cables shown are not included with the TV
VCR Setup
-To avoid picture noise (interference), leave an adequate distance between the VCR and TV
-Use the ISM Method (on the Option menu) feature to avoid having a fixed image remain on the screen for a long period of time. Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen.
Connection Option 1
Set VCR output switch to 3 or 4 and then tune
TV to the same channel number.
Connection Option 2
1. Connect the audio and video cables from the |
VCR's output jacks to the TV input jacks, as |
shown in the figure. |
When connecting the TV to VCR, match the |
jack colors (Video = yellow, Audio Left = white, |
and Audio Right = red). |
If you connect an |
the |
improved; compared to connecting a regular |
VCR to the Video input. |
COMPONENT | MONITOR |
INPUT 2 | OUTPUT |
COMPONENT |
|
| A/V |
| Antenna |
|
INPUT 1 |
|
| INPUT 1 | AC INPUT | ||
R | L | R | L/MONO |
|
|
|
VIDEO | AUDIO | AUDIO VIDEO |
2. Insert a video tape into the VCR and press |
PLAY on the VCR. (Refer to the VCR owner’s |
manual.) |
2
ANT IN
1
3. Select the input source by the TV/VIDEO but- |
ton on the remote control. (If connected to A/V |
INPUT 1, select Video 1 input source) |
Do not connect to both Video and S- Video at the same time. In the event that you connect both Video and the
ANT OUT | OUT | VCR | |
| |||
|
|
|
OUTPUT | (R) AUDIO (L) | VIDEO | |
SWITCH |
|
| |
3 | 4 | IN |
|
Cable TV Setup
-After subscribing to a cable TV service from a local provider you can watch cable TV programming. The TV cannot display TV programming unless a TV tuner device or cable TV converter box is connected to the TV.
-For further information regarding cable TV service, contact your local cable TV service provider(s).
Connection Option 1
1.Select 3 or 4 with channel switch on cable box.
2.Tune the TV channel to the same selected output channel on cable box.
3.Select channels at the cable box or with the cable box remote control.
Connection Option 2
1.Connect the audio and video cables from the Cable Box's output jacks to the TV input jacks, as shown in the figure.
When connecting the TV to a Cable Box, match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red).
2.Select the input source by using the TV/VIDEO button on the remote control. (If connected to A/V INPUT 1, select Video 1 input source)
3.Select your desired channel with the remote control for cable box.
COMPONENT | MONITOR |
INPUT 2 | OUTPUT |
COMPONENT |
|
| A/V |
|
| |
INPUT 1 |
|
| INPUT 1 | AC INPUT | ||
R | L | R | L/MONO | |||
|
|
VIDEO | AUDIO | AUDIO | VIDEO |
2 1
(R) AUDIO (L) | VIDEO |
|
|
| OUTPUT |
| |
TV | SWITCH |
| |
| 3 | 4 |
|
VCR |
| RF | Cable |
Cable Box
12 Plasma TV