LG Electronics 42PC3D, 60PC1D owner manual VCR Setup, When connecting with an antenna

Installation

VCR Setup

-To avoid picture noise (interference), leave an adequate distance between the VCR and TV.

-Typically a frozen still picture from a VCR. If the 4:3 picture format is used; the fixed images on the sides of the screen may remain visible on the screen.

When connecting with an antenna

2 VCR

ANT IN

ANT OUT S-VIDEO OUT

OUTPUT		(R) AUDIO (L)	VIDEO
SWITCH
3	4	IN

1

SERVICE

RGB IN
(PC)
AUDIO IN	REMOTE
(RGB/DVI)	CONTROL IN
HDMI IN
2

1Connect the RF antenna out socket of the VCR to the Antenna socket on the set.

2Connect the antenna cable to the RF antenna in socket of the VCR.

3Set VCR output switch to 3 or 4 and then tune TV to the same channel number.

4Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner’s manual.)

ANTENNA/ CABLE IN

1(DVI)

RS-232C IN

(CONTROL & SERVICE)

When connecting with a RCA cable

	VCR
	ANT IN
OUT	S-VIDEO ANT OUT

(R) AUDIO (L)	VIDEO	OUTPUT
		SWITCH
IN		3	4

		1
			C
	VIDEO	AUDIO	OMPONENT IN
			AV OUT
OPTICAL			AV IN
DIGITAL AUDIO	S-VIDEO VIDEO	(MONO)
		AUDIO	1
OUT

1Connect the AUDIO/VIDEO jacks between TV and VCR. Match the jack colors (Video = yellow, Audio Left = white, and Audio Right = red)

2Insert a video tape into the VCR and press PLAY on the VCR. (Refer to the VCR owner’s manual.)

3Select AV1 input source using the INPUT button on the remote control.

- If connected to AV IN2, select AV2 input source.

•If you have a mono VCR, connect the audio cable from the VCR to the AUDIO L/MONO jack of the set.

19