Audiovox FPE2706 Watching TV, Turning On/Off, Introducing Channel Number Selecting Channels

Watching TV

Turning On/Off

Turning On

Firstly, Plug in the AC power cord to the AC outlet.

Press POWER on the TV or press POWER on the remote control.

Never attempt to move the TV unless the AC power cord has been disconnected.

Introducing Channel Number

Selecting Channels

or

The initial setup starts when the TV powers on for the first time. If the TV has been

turned on before, it displays current input signal directly.

Turning Off

Press POWER on the TV or press POWER on the remote control.

The TV enters standby mode and the image on the screen disappears.

The TV will still consume some power as long as the AC power cord is still inserted into the wall outlet.

If you are not going to use this TV for a long period of time, be sure to remove the AC power cord from the power outlet.

This television is capable of receiving the full range of cable-TV channels available today, from the most digital and HDTV channels, to the traditional analog channels.

As the transition toward full digital TV continues, some cable-TV systems in the USA will have a mixture of analog and digital channels in their lineups. So in most situations the ATSC PSIP channel number is composed of a major channel number and a minor channel number. The major channel number is same for both analog and digital channels (It is equal to the NTSC channel number for existing broadcasters). An analog channel usually has a minor channel number of zero, while a digital channel usually has a minor channel number of 1, 2 or larger.

You can select analog channels in serveral ways.

Method 1 - Using CH+ or CH- on the remote control or on the TV

Press the CH+ or CH- to cycle among all available channels. Only those channels marked with a tick symbol can be selected by the CH+ or CH- button.

Method 2 - Using FLASHBACK on the remote control

Press FLASHBACK to switch to the previously tuned

channel.

Press FLASHBACK again to switch back to the currently

tuned channel.

Method 3 - Using 0-9 and OK on the remote control

For analog TV channels

Press the 0-9number buttons to input a channel number and

confirm with OK to select up to 125 channels for

VHF/UHF/CATV.

24