Z Microsystems GLIDER 20 manual Setup, Setting UP Glider

Setup

SETTING UP GLIDER

The outer Z-lock bracket fits snuggly against the female Z-lock bracket attached to the cabinet frame.

Lift and slide the two display lock knobs at the back of the display to the open or inward positions. This allows the display top to be lifted from its storage position.

Holding the base with one hand, lift the back of the pivioted display up to the vertical position.

With both hands, press both the Z-Locks down.

Push down on the latch at the base of the display. Then lift the raised latch from its receptical to the unlatched position.

VERY IMPORTANT.

Hold the top of the display in the vertical position while rotating the latch clockwise to the locked position.

12

Slide the Glider all the way out to the safety stop.

Rotate the latch counter- clockwise to unlock the latch.

Once the display is locked in position, lower the latch back into the base recepticle.

Doc# 27-0006UM Issued 11/00 Rev 1.0