Install the Slides in Cabinet Frame

Each slide unit includes the slide rail, the front Z-Lock mount and the rear mount.

The top notch of the Z- Lock must align with the slide rail top ridge.

On the rear of the cabinet frame, use three Phillips screws to loosely secure the right and left rear slide mounts to the cabinet frame.

DO NOT tighten these screws fully.

As seen from this reverse view, align the slider into the Z-Lock bracket grooves so all three screw holes show.

On each slide rail, use a Phillips screwdriver to loosen the two adjust- ment screws toward the back of the slide rail.

An adjustable wrench or box wrench may be used to hold the nut on the other side of the slide rail.

On the front of the cabinet frame, use three Phillips screws and washers per side to secure the right and left Z-Lock mounts holding the sliders.

DO NOT tighten these screws to allow for adjustment of the Glider within the cabinet frame.

At the back of the cabinest frame, tighten the slide mounts to the cabinet frame.

Make sure to hold the slide mounts hard against the rack rail.

Doc# 27-0006UM Issued 11/00 Rev 1.0