Installation to Single Wood Stud Wall

WARNING

•Installer must verify that the supporting surface will safely support the combined weight of all attached equipment and hardware.

1	Use a stud finder to locate the edges of the stud. Use of an edge-to-edge stud finder is highly recommended. Based
	on its edges, draw a vertical line down the stud’s center. Place wall plate (AA) on wall as a template, making sure

that the three mounting holes are over the stud centerline. The top mounting hole should be 2.5" above the desired screen center as shown in figure 1.1. Level plate, and mark the center of the three holes. Drill three 5/32" (4 mm) dia. holes 2-1/2" (65 mm) deep. Make sure that the wall plate is level, secure it using three #14 x 2.5" wood screws (CC) as shown in figure 1.2.

Skip to step 2 on page 7.

WARNING

•Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the screws, greatly reducing their holding power.

•Never tighten in excess of 80 in. • lb (9 N.M.).

•Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is highly recommended.

•Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers are responsible to provide hardware for other types of mounting situations.

CS = center of screen

2.5"

(64 mm)

fig. 1.1

fig. 1.2

4 of 9

ISSUED: 08-02-05 SHEET #: 202-9010-1