Installation to Solid Concrete or Cinder Block
WARNING
•When installing Peerless wall mounts on cinder block, verify that you have a minimum of
•Concrete must be 2000 psi density minimum. Lighter density concrete may not hold concrete anchor.
•Make sure that the supporting surface will safely support the combined load of the equipment and all attached hardware and components.
1 | Place wall arm (A) on wall as template, level, | 1 |
| concrete |
| and mark the center of two mounting holes. Top |
| surface | |
| mounting hole will be 6.66" above the center of |
|
| D |
| display mounting plate as shown in fi gure 1.1 on |
|
| |
| page 4. Drill two 5/16" dia. holes to a minimum |
|
| |
| depth of 2.5". Insert anchors (D) into holes fl ush |
|
|
|
| with wall as shown. Secure wall arm (A) to wall with | Drill holes and insert anchors (D). |
|
|
| two wood screws (C) as shown in fi gure 1.3. For | 2 | A |
|
| cable management option, install cable anchor (I) to |
| ||
| bottom mounting hole with wood screw (C). |
|
|
|
| NOTE: Be sure arrow is pointing up when mounting |
| C | D |
| wall arm assembly (A) to wall as shown in fi gure |
| ||
| 1.1. Level, then tighten all fasteners. | Place plate (A) over anchors (D) and secure with screws (C). |
| |
| Insert two fastener caps (H) into wall plate mounting |
| ||
|
|
|
| |
| holes. | 3 |
|
|
WARNING
• Tighten screws so that wall plate is fi rmly attached, |
|
|
|
|
|
|
|
|
|
| |
but do not overtighten. Overtightening can damage |
| Tighten all fasteners. | |||
screws, greatly reducing their holding power. |
|
|
|
|
|
|
|
|
|
|
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Always attach concrete expansion anchors directly | SOLID CONCRETE | CINDER BLOCK |
to |
| |
|
|
• | Never attach concrete expansion anchors to |
| ||
| concrete covered with plaster, drywall, or other | D | ||
| fi nishing material. If mounting to concrete surfaces | |||
| covered with a fi nishing surface is unavoidable (not |
| ||
| evaluated by UL), the fi nishing surface must be |
| ||
| counterbored as shown below. Be sure concrete | C | ||
| anchors do not pull away from concrete when | |||
| tightening screws. If plaster/drywall is thicker than | H | ||
| 5/8" (16 mm), custom fasteners must be supplied by | |||
| installer (not evaluated by UL). |
| A | |
VIEW | INCORRECT | CORRECT |
| |
concrete | wall | concrete |
| |
| wall | plate |
|
|
| plate |
| I | |
|
|
| ||
CUTAWAY |
|
|
| |
drywall |
| drywall | fig. 1.3 | |
| plaster/ |
| plaster/ |
|
|
|
| 5 of 29 | ISSUED: |