Extension Arm Installation (Optional)
Please see the Operator’s Manual to determine the correct throw distance (the distance from the projector to the screen) must be determined prior to mounting the projector.
If the extension arm was purchased at a later date, the end cover must be removed prior to installing the extension arm.
1/4” Flat
Washers
1/4” Nylon
Spacer
M6 x 12
Security Screw
Security
Wrench
Upper
Mounting
Bracket
Extension Arm
Step 1. Slide the extension arm into the open end of the
Step 2. Attach the upper mounting bracket directly to the extension using two (2) M6 x 12mm set screws (see page 8). Step 3. Adjust length so that the center of the upper mounting bracket matches the throw distance calibration.
Step 4. Line up the mounting holes on the extension arm with the mounting slots on the
Step 5. Using a screwdriver, insert and tighten two (2) M6 x 12mm security head screws, 1/4” flat washers and 1/4” nylon spacers. Step 6. Attach the
Base Box Installation
Please review the Operator’s Manual that came packaged with the
Projector Mount
M6 x 12mm Screws
Security Wrench
Base Box
Step 1. | Raise the base box projector mount to the upper mounting bracket. |
|
Step 2. | Align the two (2; one each side) mounting holes. |
|
Step 3. | Using a screwdriver/security wrench, insert and tighten two (2) M6 x 12mm security head screws. Do not over tighten the | |
| screws. |
|
Step 4. Attach the projector to the base box, referring to the | ||
|
| |
Page 10 | Installation Instructions | |