LPFM1532
Determining the Mounting Hardware
Step 1. Insert the thread depth indicator (supplied) through the thread inserts found on the back of the flat panel. Step 2. Using a pencil, mark the depth of the thread insert on the thread depth indicator (Figure 2).
Step 3. Compare and verify the depth of the remaining thread inserts. Step 4. Locate the correct diameter screw for the thread insert.
Step 5. Compare your thread depth indicator marking to the screw length.
If your selected screw is longer than
the marking on the thread depth indicator, do not use this screw. The screw length must not bypass the
marking. If so, select another screw size (Figure 2 and 3) until you find the
screw the comes closest to your mark without going past the marking.
When using the universal spacers in the installation, make sure to account for the appropriate spacing depth when measuring with the thread depth indicator. Using the universal spacers will change the overall length of the hardware used.
Figure 1
Inverted Flat Panel Display
Marking the Depth
Thread Insert
Thread Depth
Indicator
Screw | Marking | Screw | Marking |
|
|
| |
Thread Depth | Thread Depth | ||
Indicator | Indicator | ||
Figure 2 | Figure 3 |
|
Universal Spacers Installation
You may not need to use any spacers for your particular flat panel.
The universal spacer may be stacked five (5) high, for a total stacking height of
The universal spacer will fit M4, M5, M6 and M8 screws sizes.
Page 6 | Installation Instructions |