Unisen 154 Series A/V Receiver with HDMI Output, A/V receiver back panel, DVD player, types

2. TV Connections 27

A/V Receiver

Most setups require either a digital audio cable or analog stereo audio cables. To send audio from TV channels received on the ANT input or devices con- nected directly to the TV, you must use one of the con- nections shown below.

The TV makes all audio available in digital and analog formats:

•Analog audio coming into the TV is available as output in digital stereo format on the DIGITAL AUDIO OUTPUT jack.

•Digital incoming audio is available as analog output on the AVR/SURROUND OUTPUT L and R jacks.

Optical cable (digital A/V receiver)

or	Stereo analog cables
	(analog A/V receiver)

OPTICAL

INPUT

COAXIAL

INPUT

A/V receiver back panel

Note:

•On rare occasions, an HDMI signal may be copy-restricted and cannot be output from the TV as a digital signal. To hear these copy- protected signals through the A/V receiver, use the connection for an analog A/V receiver.

•Check the A/V receiver’s Owner’s Guide for information concerning use of the digital input and switching between digital sound and analog stereo sound from the TV.

Downloaded From TV-Manual.com Manuals

A/V Receiver with HDMI Output

Required: One HDMI-to-HDMI cable

This option allows you to view content from devices connected to an A/V receiver. The A/V receiver can send audio and video to the TV over a single HDMI cable. You can use an HDMI connection as described here in addition to an audio connection from the TV’s audio output. The optional audio connection allows you to hear, through the A/V receiver, devices connected to the TV only, e.g., an antenna on the ANT input.

•You may be able to use the TV’s remote control (in TV mode) to operate connected CEC-enabled HDMI devices. Experiment with your equipment to determine which functions are available to the TV’s remote control. See Appendix C, page 81.

•265 Series: This setup allows you to use NetCom- mand-controlled audio and video switching over the HDMI cable. See “Automatic Audio/Video Switch- ing Over an HDMI Connection” on page 69.

•265 Series: To use NetCommand to supplement HDMI control of a CEC-enabled A/V receiver, note the recommendations under “More About Using an HDMI Connection,” page 69.

TV

	Optional
HDMI cable	analog or
	digital audio
	connection

A/V receiver with	HDMI OUT	OPTICAL	R	L
		AUDIO IN	ANALOG AUDIO IN
HDMI output

Any connection	VCR
types
High-definition
DVD player	DVD player
	Cable box

For assistance call 1(800) 332-2119