Unisen 154 Series Appendix C HDMI Control of CEC Devices, Enabling HDMI Control of CEC Devices

Appendices81

Appendix C: HDMI Control of CEC Devices

Many new HDMI devices have a feature called Con- sumer Electronics Control (CEC) or HDMI Control. HDMI Control allows one device, such as the TV, to control other devices, such as an A/V receiver or disc player. Use of CEC is optional.

Each manufacturer chooses which CEC functions to support so it is difficult to predict which devices and features are compatible with Mitsubishi’s HDMI Control. You may find that CEC functions for a specific device are limited.

To use HDMI Control, you must enable it in both the TV and the device.

•In the TV. Enable HDMI control from the New Device Found screen or from the Inputs > HDMI Control menu.

•In the Device. Most devices with HDMI CEC com- patibility let you turn it on or off in the device menus, where it is typically listed as “HDMI Control.”

Enabling HDMI Control of CEC Devices

To ensure proper detection

•Power on HDMI devices before connecting them to the TV.

•Connect and set up HDMI devices one at a time.

1.Power on the device and allow it to complete the power-on sequence (boot up). Stop any playback.

2.Connect the device to one of the TV’s HDMI inputs.

3.When the TV detects the connection, the New Device Found screen will appear.

Note: See “If the New Device Found Screen Has No HDMI Control Option” on this page if there is no HDMI Control option.

New Device Found screen with HDMI Control option. This screen displays only if the device’s HDMI Control is enabled.

4.If prompted for a name, highlight a name for the device and press ENTER to add a check. The device itself may later override the name assigned.

5.Highlight On and press ENTER to add a check.

7.Highlight EXIT and press ENTER to close the New Device Found screen.

Note: At any time after completing Auto Input Sens- ing, you can set the TV’s HDMI control on or off in the Inputs > HDMI Control menu.

8.265 Series. To supplement HDMI control with NetCommand IR control, see page 60.

If the New Device Found Screen

Has No HDMI Control Option

If the New Device Found screen shows no option for HDMI Control, one of these conditions applies:

•HDMI Control is turned off in the menus of the new device

Action:

a.Highlight EXIT and press ENTER to close the New Device Found screen.

b.Display the device’s setup menus and enable the device’s CEC capabilities.

c.Wait for the TV’s New Device Found screen to appear again.

d.If the New Device Found screen does not appear, power off the device. Power on the device and wait for the New Device Found screen to display with the HDMI Control option.

•The HDMI cable cannot support CEC

Action:

Upgrade your HDMI cable to one that supports CEC.

•The device does not have CEC compatibility Action:

-- Control the device with its own remote control or program the TV’s remote control to operate the device.

-- 265 Series. Use the TV’s NetCommand IR control (page 60).

Downloaded From TV-Manual.com Manuals

For assistance call 1(800) 332-2119