Preparing and Using the Remote Control
How to insert the batteries
1 Open the battery compartment cover. | 2 Insert the batteries. |
Remove the cover by pushing down where | Insert two AAA batteries by matching the + |
the cover edge is marked and slide the cover | and - terminals on the batteries to the dia- |
backwards. | gram inside the battery compartment. |
| (Make sure that the poles are facing the cor- |
| rect direction.) |
3 Close the battery compartment cover. Rest the cover along the back with the clip aligned and push/slide the cover until you hear it click into place.
SET UP
How to use the remote control
•When operating the remote control, point its top edge at the remote control IR receiver on the TV. Operate the remote control within seven meters, 30° on the left and right and 15° above and
below the receiver.
• If the TV cannot be operated by remote control operation (but by the buttons on the TV), a probable cause is that the batteries in the remote control have reached the end of their service life.
•Replace with new batteries.
•Do not leave or attach the remote control in a location subject to direct sunlight.
•Heat may deform the remote control and cause it to malfunction.
•The remote control becomes more difficult to operate if direct sunlight or bright overhead lighting falls on the remote control IR receiver on the TV. Either
•Do not subject the remote control to strong impact. Also, do not allow it to get wet or leave it in very hot locations.
15