
Memorizing Channel Manually
1.On the Channel menu, select the third option, (Manual Scan), and then use the
or
button to select (Manual Scan).
2. Press “OK” to highlight the input col- |
umn. Then press numerical buttons to |
input the channel. The channel frequen- |
cy will be automatically shown on right |
side of the input column. |
3. Press “OK” when the messages “Add |
channel” and “press Enter to add chan- |
nel” are shown. |
4. If the ATSC signal is found and locked, |
Channel Caption
Edit
Auto Scan
Manual Scan
Channel Caption
Setup Lock
Setup Lock
the (status) will show the message (Get |
No.XX 8VSB channel success), press |
“EXIT” or “DTV MENU” to leave the |
menu page, watch the program, or scan |
other channels. |
5. If the signal is not locked, the status will |
show “Got No Channel”. You can scan |
the signal again or refer to the signal |
level bar “Signal” for aligning the direc- |
tion of the antenna to get the signal. |
6. When the signal is locked and the prod- |
uct is on the channel, you can enter this |
page to check the signal level. |
Note: Contact the antenna installer it you |
are haveing trouble locking the signal. |
7. Press “EXIT” to go back to the main |
menu or press “DTV MENU” to leave. |
Manual Scan
OFF AIR
Channel No : 34 | Freq : 593000 |
Add channel
Status : Press [Enter] to Add channel.
Signal : 72 %
Channel | Caption | Setup | Lock |
Manual Scan
OFF AIR
Channel No : 0
Status : Add No. 34 8VSB channel successfully.
Signal : 0 %
45