Insignia NS-42L550A11, NS-32L550A11 Connecting a VCR, Connecting a computer, To connect a VCR

NS-32L_37L_42L550A11_09-1120_MAN_V2_English.book Page 17 Thursday, January 21, 2010 10:20 AM

32"/37"/42" LCD, 120 Hz 1080p

Connecting a VCR

Note

The AV IN VIDEO jack and the AV IN S-VIDEO jack share the same audio jacks. You cannot connect both types of devices at the same time.

To connect a VCR:

1Make sure that your TV’s power cord is unplugged and the VCR is turned off.

2Connect the video connector on a composite cable (not included) to the AV IN VIDEO jack on the back of your TV and the VIDEO OUT jack on the VCR.

Back of TV

Cables are often color-coded to match color-coded jacks. Connect yellow to yellow, red to red, and white to white.

VCR

3Connect the left and right audio connectors on the composite cable to the AV IN L/R audio jacks on the back of your TV and to the AUDIO OUT jacks on the VCR.

4Turn on your TV, then turn on the VCR.

5 Press INPUT to open the Source List.

6Press or to highlight AV, then press OK/ENTER.

7Insert a videotape into the VCR, then press the play button.

Connecting a computer

To connect a computer:

1Make sure that your TV’s power cord is unplugged and the computer is turned off.

2Connect a VGA cable (not included) to the VGA jack on the back of your TV and to the VGA jack on the computer.

Back of TV

3Connect an audio cable to the

PC/DVI AUDIO IN jack on the back of your TV and to the AUDIO OUT jack on the computer.

4Turn on your TV, then turn on the computer.

5 Press INPUT to open the Source List.

6Press or to highlight VGA, then press OK/ENTER.

Note

When the computer enters Standby mode, your TV turns off. If your TV does not turn on when you “wake” your computer, press (power) on your TV or remote control.

For HDMI-DVI input from PC, the TV will enter Standby mode after one minute if no signal is detected.

www.insigniaproducts.com 17