IDEAL INDUSTRIES 45-935, 45-930 Strip Length Adjustment, by Discrete Value, Cycle Mode

STP Operation continued

Strip Length Adjustment, by Discrete Value

METRIC LENGTH MODE (31 mm to 152 mm)

•Press STRIP LENGTH.

•The strip length display will blink.

•Enter the strip length and then press ENTER.

A strip length is automatically entered after a third digit is pressed.

For Example Enter Value of 75 mm:

STRIP	20%	10	40	0	ENTER
LENGTH
Press	ENTER		VALUE	Press Numbers	Press
		Digit Will Blink		7 Then 5

ENGLISH LENGTH MODE (1-1/4 inches to 6.00 inches)

•Press STRIP LENGTH.

• The first digit will blink. Press the appropriate number key and it will be entered.

•Press the decimal point.

•The tenths digit will blink, press the appropriate number key.

•Next the hundredth position will blink, press the appropriate number key.

•After typing the hundredth position, the new strip length is set.

If at any time during the strip length entry ENTER is pressed, the current strip length will be set. If CLEAR is pressed during a strip length entry, it returns to the beginning of the strip length entry mode. If CLEAR is pressed at the beginning of the strip length entry mode, it exits the strip length entry mode and the previous settings are returned.

For Example Enter Value 3.25 Inches:

STRIP	20%	10	40	0.00		BATCH	20%	10	40	3.00	20%	10	40	3.20
LENGTH
Press	ENTER		VALUE		Press 3	Press	ENTER	VALUE			ENTER VALUE			Press 5
											Press 2
	First Digit Will Blink						Second Digit Will Blink				Third Digit Will Blink

Strip Length Adjustment By Increment

While in the ready mode, the strip length can be changed up or down by increments using the [ ↑ ] and [ explained in the Set section of Program.

↑

] keys. Programming the increment is

In either of the strip length entry methods, the strip length is checked. If the strip length is invalid, an appropriate message appears and the previous strip length is displayed.

Cycle Mode

NORMAL STRIP CYCLE	PRGM.
• To select a new cycle mode, press Program/High	HIGH
• Enter in the 3-digit security code	Press

Note: All units are factory preset to a 3-digit security code of “111.” To make any changes in the Program Mode the security code must be entered.

• The display will show

1	- Test	2 - Set
3	- Mode	Clear_Esc

•Select [3] for Mode

•Select [1] NORMAL CYCLE MODE

•Press count/clear on your key pad

•Self Check - Press enter and hold to display batch number and selected cycle mode.

•Insert wire for normal cycle mode

•Remove wire when cycle is completed

7