UNPACKING
When unpacking, check to make sure that all the parts and accessories listed on pages 21 and 22 are included, and the product is intact and undamaged. If any parts are missing or broken, please call Harbor Freight Tools at the number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
NOTE: For Additional information regarding the parts mentioned in the following pages, refer to the Assembly Diagrams on pages 21 and 22.
CAUTION! The Blast Cabinet weighs approximately 250 pounds, and will require additional assistance and/or a proper lifting device during the assembly procedures.
1.Remove all parts from within the Cabinet (22). Then, with assistance, carefully place the Cabinet upside down on the floor surface. (See Figure F.)
2.Attach the four Cabinet Legs (23) to the Cabinet (22), using five Bolts (42) per
Cabinet Leg. NOTE: The front left Cabinet Leg should have a name plate on it. Each of the two rear Cabinet Legs will also require two
(See Figure F.)
3.Once the Cabinet Legs (23) are attached to the Cabinet (22), stand the Cabinet upright on its Cabinet Legs. (See Figure F.)
CABINET | BOLT | BOLT | CABINET | ||
(22) | (22) | ||||
|
| (42) | (42) |
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| FRONT |
| |
| LEFT SIDE | VIEW |
| |||
|
|
| RIGHT SIDE | |||
| VIEW |
|
| VIEW | ||
BOLT |
| BOLT | BOLT | BOLT | ||
(42) | (42) | (42) | (42) | |||
|
|
| CABINET LEG | CABINET LEG |
|
|
|
|
|
|
| ||
| (23) | (23) |
|
| ||
FIGURE F
SKU 94274 | For technical questions, please call | PAGE 11 |