42
This chapter describes how to connect additional video equipment to the television.
A decoder can be connected to the television via the AV2 socket. If your setup also includes a Bang & Olufsen video recorder, you should connect the decoder to the video recorder.
A
Connect additional video equipment
Connect a decoder
BeoCenter | Primary decoder |
Secondary decoder
When you connect a Bang & Olufsen video recorder, you must connect it to the AV1 socket, the television detects the connection automatically.
Make sure that all connected equipment is registered in the CONNECTIONS menu. For further information, refer to the chapter ‘Register additional video equipment’ on page 46.
Disconnect all involved systems from the mains before you connect external equipment.
>Connect the cable from the external aerial to the socket marked TV on the television.
>Connect the decoder to the
If you wish to connect an RF decoder, connect the external aerial cable to the decoder input socket and then forward the signal or cable to the television’s aerial socket (marked ‘TV IN’).
Tuned programs and decoder detection
In most cases, a connected decoder is registered automatically during tuning. The decoder should automatically detect those programs which require decoding. However, if this is not the case, then adjust the setting via the MANUAL TUNING menu for the program in question. Please refer to the section entitled ‘Adjust tuned TV programs’ in the chapter ‘Edit tuned programs’ on page 23.