Black Box PCW22A-R3, PCW22A-R4 manual Command PASS-THRU

Page 15

PROTOCOL CONVERTER A/S-2G

3.4.8 COMMAND PASS-THRU

To use the command pass-thru feature, the command must be preceded by &% and terminated by &%.

Example: &%-Command-&%

Commands consist of character pairs. Each pair must represent a valid Hexidecimal value (i.e. zero through 9 or A through F). Example: To send an escape sequence to an attached ASCII device, such as “ESC A,” the following EBCDIC string must be sent to the A/S-2G: &%lB41&%.

14

Image 15

Contents Protocol Converter FCC Statement Protocol Converter A/S-2G Table of Contents Synchronous Device to Asynchronous Device RXC SpecificationsIntroduction Installation Unpacking and InspectionData Flow Control 2 SW2 SELF-DIAGNOSTICS Switch #4 on =5 RS-232 PASS-THROUGH Options Reconfigure Switch ModeReset Options Data Terminal Ready DTR Signal OptionsClear to Send CTS Signal Options Baud Rate OptionsModem or DIRECT-TO-TERMINAL Connection Preparing the A/S-2G for Connection to a Synchronous Device Carrier OptionsCable Requirement External or Internal Clocking Option Command PASS-THRU Asynchronous Device to Synchronous Device OperationFlow Control USE of Carriage Return a 2770/2780 ModePresentation of Data from A/S-2G to Synchronous Device Verification of Data ReceptionLine Turnaround Data Flow A/S-2G to Synchronous Device NAK Echo CR LF Send block F Echo all but CR LF Data Flow A/S-2G to Synchronous Device Synchronous Input Data Format Synchronous Device to Asynchronous DeviceEbcdic characters stripped Data Flow A/S-2G to Asynchronous Device Operation EOT Transparency Mode of Operation Installing or Replacing PromsConversions and Connections GND RS-232 Cable ChartCode Conversions Special Conversions Printed Board Circuit Layout Printed Circuit Board LayoutPark Drive Lawrence, PA