Black Box PCW22A-R4, PCW22A-R3 manual Installation, Unpacking and Inspection, Data Flow Control

Page 8

CHAPTER 3: Installation

3.0Installation

3.1UNPACKING AND INSPECTION

After unpacking the A/S-2G, inspect it for shipping damage. Should there be any noticeable damage, save the cartons and contact the carrier who delivered the box to place a freight damage claim.

To open the A/S-2G, take out the four screws from the bottom. Lift off the cover. With the cover removed, visually inspect for components that may have been loosened in shipment. Shipping damage is rare, but a quick inspection is always good practice.

Leave the cover off for installation.

3.2 DATA FLOW CONTROL

For the locations of the switches and jumpers, see Figure 5-2 on page 28.

3.2.1 SW3

Locate the set of 8 asynchronous switches labeled SW3 on the printed circuit board. (See Figure 5-2 on page 28.) These should be set as follows:

Switch #l ON = echo asynchronous characters — echoplex mode.

OFF = don’t echo asynchronous characters — normal mode.

Set this switch ON when the asynchronous device expects to receive an echo of its transmitted data.

NOTE

The A/S-2G always operates in half-duplex mode on the synchronous side, so this option applies only to the asynchronous device.

Switch #2 ON = echo “EOT” character.

OFF = don’t echo “EOT” character.

The last record received from the asynchronous device must be terminated with a “Control D” character. For this character to echo to the asynchronous device, switch #2 must be ON. This character is echoed only after the EOT sequence is sent to the synchronous device. Its echo appears as a CR LF, EOT.

NOTE

An EOT from the bisynchronous device will be displayed in the same way to the asynchronous device with this switch ON.

Switch #3 ON = do not include CR (carriage return) character in EBCDIC data.

OFF = include CR character in EBCDIC data

Each block sent by the asynchronous device (except the last one) must be terminated with a CR (carriage return) code. If this CR code will be included in the synchronous EBCDIC data as a new line, this switch must be OFF.

NOTE

The 3741 protocol is limited to a block size of 128 characters (the block size is also the record size), thus a CR must be entered not later than each 128 characters.

7

Page 7 Page 9
Image 8
Page 7 Page 9
Contents Protocol Converter FCC Statement Protocol Converter A/S-2G Table of Contents Synchronous Device to Asynchronous Device Specifications RXCIntroduction Data Flow Control InstallationUnpacking and Inspection 2 SW2 Switch #4 on = SELF-DIAGNOSTICSReconfigure Switch Mode Reset OptionsData Terminal Ready DTR Signal Options 5 RS-232 PASS-THROUGH OptionsModem or DIRECT-TO-TERMINAL Connection Clear to Send CTS Signal OptionsBaud Rate Options Cable Requirement Preparing the A/S-2G for Connection to a Synchronous DeviceCarrier Options External or Internal Clocking Option Command PASS-THRU Operation Asynchronous Device to Synchronous DeviceUSE of Carriage Return a 2770/2780 Mode Flow ControlLine Turnaround Presentation of Data from A/S-2G to Synchronous DeviceVerification of Data Reception Data Flow A/S-2G to Synchronous Device NAK Echo CR LF Send block F Echo all but CR LF Data Flow A/S-2G to Synchronous Device Synchronous Device to Asynchronous Device Synchronous Input Data FormatEbcdic characters stripped Data Flow A/S-2G to Asynchronous Device Operation EOT Conversions and Connections Transparency Mode of OperationInstalling or Replacing Proms RS-232 Cable Chart GNDCode Conversions Special Conversions Printed Circuit Board Layout Printed Board Circuit LayoutPark Drive Lawrence, PA
Top Page Image Contents