Black Box PCW22A-R4, PCW22A-R3 manual Ebcdic characters stripped

Page 24

CHAPTER 4: Operation

Should the A/S-2G receive a DLE EOT (disconnect), the A/S-2G will cycle the synchro-nous DTR lead off for 2 seconds. This action will disconnect a phone line if the DTR B jumper is set for CNT.

NOTE

The A/S-2G will cycle the synchronous DTR lead off for 2 seconds whether the DLE EOT sequence comes from the synchronous or asynchronous side.

		EBCDIC CHARACTERS STRIPPED
Character	Hex	Character	Hex
NUL	00	ACK	2E
SOH	01	DLE	10
STX	02	NAK	3D
ETX	03	SYN	32
EOT	37	ETB	26
ENQ	2D

Table 4-4. EBCDIC characters stripped.

23

Image 24

Contents Protocol Converter FCC Statement Protocol Converter A/S-2G Table of Contents Synchronous Device to Asynchronous Device Specifications RXCIntroduction Installation Unpacking and InspectionData Flow Control 2 SW2 Switch #4 on = SELF-DIAGNOSTICSReconfigure Switch Mode Reset OptionsData Terminal Ready DTR Signal Options 5 RS-232 PASS-THROUGH OptionsClear to Send CTS Signal Options Baud Rate OptionsModem or DIRECT-TO-TERMINAL Connection Preparing the A/S-2G for Connection to a Synchronous Device Carrier OptionsCable Requirement External or Internal Clocking Option Command PASS-THRU Operation Asynchronous Device to Synchronous DeviceUSE of Carriage Return a 2770/2780 Mode Flow ControlPresentation of Data from A/S-2G to Synchronous Device Verification of Data ReceptionLine Turnaround Data Flow A/S-2G to Synchronous Device NAK Echo CR LF Send block F Echo all but CR LF Data Flow A/S-2G to Synchronous Device Synchronous Device to Asynchronous Device Synchronous Input Data FormatEbcdic characters stripped Data Flow A/S-2G to Asynchronous Device Operation EOT Transparency Mode of Operation Installing or Replacing PromsConversions and Connections RS-232 Cable Chart GNDCode Conversions Special Conversions Printed Circuit Board Layout Printed Board Circuit LayoutPark Drive Lawrence, PA