CONTRACT INSTALLATIONS
The manufacturer is in no way affiliated with any professional pool installer. Therefore the manufacturer can assume no responsibility for errors in installation by the home owner or said professional installer. If you have your POOL installed by others, please supervise them to be sure they comply with the proper installation techniques shown. Their past expe- rience or short cuts may not cover the latest improvements in our POOLS. Do not allow any short cuts of any nature.
LOCAL CODES
•Local building code may require obtaining a building permit and or an electrical permit. The installer shall follow the regulations on set backs, barriers, devices and other conditions.
•Any after market or home built deck should be built to the local building code requirements, including load capacity and fencing requirements.
•All electrical outlet connections should be a minimum of 5 feet from the outside perimeter of the wall of the pool. From
•Severe electrical shock could result if you install your pump or filter on a deck. They could fall into the water, causing severe shock or electrocution. Do not install on a deck or other surface at, above or slightly below the top ledge of the pool.
BARRIER REQUIREMENTS
•If the distance from the top of the assembled pool is less than 48" vertically from the surrounding grade, a fence or barrier is needed to surround the pool with a minimum height of 48".
•A barrier is necessary to provide protection against potential drowning and near drowning and is not a substitute for constant supervision of children. A barrier is a fence, wall, or a combination thereof which completely surrounds the swimming pool and obstructs access to the swimming pool. Barriers must comply with local and national building codes and the US Consumer Product Safety Commission.
•These are minimum fencing and barrier requirements. Check your local building codes for other requirements they may request. Optional fencing kits are available, Please contact your local dealer.
•If pool covers are used for safety barriers they should comply with ASTM F 1346 "Standard Performance Specification for Safety Covers and Labeling Requirements for All Covers for Swimming Pools, Spas and Hot Tubs."
SPECIAL CARE
Even though this manufacturer's pools are designed to meet or exceed industry recommended safety factors, special attention must be paid to some installation procedures that the installer performs and controls.
•Levelness Spend the time to assure that the entire pool framework is level within 1". Unlevel pools place extreme pressures on the pool walls.
•Wall seam This area is where the wall joins together. Damage to any part of this area reduces the safety factors and can result in a weak pool. Use extreme care following instructions.
•Earth mound This keeps the liner from creeping out from under the pool wall. Follow instructions to the letter
–don't
•This manufacturers pools are not designed to be buried. Outside ground forces can collapse pool wall. Certain conditions may exist, like the levelness of the pool area that require the pool to be recessed. You must maintain a finished pool height of 36” above ground level. If your pool is 48” deep, you may recess the pool by 12”
•The pool owner has the sole responsibility for providing adequate lighting for the pool area.
•All users must be able to see the shallow depth of the pool, and safety signs at all times.
•You must install a pool ladder(s) and/or steps for entry and exit from the pool.
•The use of artificial pool lighting is at the discretion of the pool owner.
•All electrical components shall be installed in accordance with Article 680 of the National Electrical code 1999 (NEC®) “Swimming Pools, Fountains and Similar Installations” or its latest approved edition.
2
