16
PROTECT YOUR LINER 14
Once the wall is closed and
screws and nuts are tightened
securely, cover the screw heads
on the inside of the pool with a
cloth tape all the way from top to
bottom of wall. If the filter inlet and
outlet are not used, tape over the
prescored areas on the inside of
the pool wall.
Cloth tape or duct tape is
available through your local pool
dealer or hardware store.
VIEW FROM
INSIDE OF POOL
WALL
SEAM
SKIMMER
RETURN
FITTING
SKIMMER
INLET FITTING

CLOTH TAPE

OR DUCT TAPE

RECHECKING YOUR WORK 15FILLING THE TRENCHES 16
Measure from the last
strap to the outer end
of the pool.
Measurements in both ends
should be equal. Also make
sure that the sides of the
pool between the straps
are straight.
Confirm that the strap
assemblies are "square"
by measuring diagonally
across from the first strap
to the last strap.
Make sure that the Support
Posts on each side of the pool
are lined up in a straight row.
POOL WALL
VIEWED FROM
ABOVE
36” 36” 36” 36” 36”
36” 36” 36” 36” 36”
Also, the measurements from the center of one strap to the center of the next one should be 36".
Fill the trenches and all open areas in
and around the Bottom Supports with
screened damp earth or pre-washed sand.