Using a #10 x 1" sheet metal screw, attach the bottom cover to the vertical using
the hole shown at right.
Hook the underside inside part of the top cover under the ledge as shown. Then lower the top cover until it rests evenly on the ledge. Place a ¼"-14 x 1" self-tapping screw through the slot in the bottom cover and screw into the hole in the top cover. Be careful not to overtighten!
INSIDE COVER
OUTSIDE FULL CONTOURED
COVER
If your pool vertical does not have a hole, simply use the cover
as a template and drill through the vertical using a 9/64" diameter drill bit, being careful not to damage the pool wall.
COVERS FOR 9" LEDGE POOLS
STAINLESS STEEL SCREW
Slide inside cover (the cover which will be closest to the inside of the pool) into position and place outside cover onto top of inside cover aligning the holes together with cage nut attached to the top plate and secure using the 1/4”-20 x 3/4” screw provided. The two (2) edges of the covers should be parallel. Before tightening the screws, press the two covers firmly together.
Line up the hole in bottom of cover with the hole in the vertical and fasten securely using the No. 10 x 1” self tapping sheet metal screw provided.
OUTSIDE FULL
CONTOURED COVER
6" & 7" TWO-PIECE FULL CONTOURED COVER
#10X1” SELF
TAPPING SCREW
NOTE: CAGE NUTS AND TOP COVER SCREWS NOT NEEDED FOR THIS STYLE.
CORRECT
LEDGE
COVER
BOTTOM
It is very
important
that the ledge be fitted inside the tab in the bottom cover as shown below.
Make sure that the
ledge remains in
this position.
INCORRECT
LEDGE
COVER
BOTTOM
TOP COVER
LEDGE
COVER BOTTOM
25
