EZ HOOK LINER INSTALLATION
ATTENTION: An 8 inch cove must be placed all around the inside of the pool
1. Clear all sticks and sharp objects from an area near the pool, |
that is as large as the pool itself. Remove the liner from its |
carton and unfold and open the liner. Refold the liner so that |
it can easily be carried to the pool and unfold from the outside |
of the pool. Check the levelness of the sand in the pool and |
make sure that no sharp objects are still in the pool. |
OPTIONAL
WALL
GUARD
8”
2. Place the liner into the pool while holding onto the top of the |
wall section of the liner. |
COVE
12”
8”
3. | Place the EZ Hook of the liner onto the top of the wall around the |
| entire pool. Temporarily place a few of the top rails over the liner |
| edging to support and sturdy the wall. Continue in this manner |
| around the entire pool. |
4. | Gently pull on the liner and use a soft bristle broom to remove |
| as many wrinkles as possible on the bottom of the pool. |
5. | Start filling the pool slowly with water. Continue pulling gently |
| and working the liner with a broom as needed. |
6. | Some wrinkling of the liner may be evident and in no way |
| affects the structural strength of your pool. Once the water |
| is filled to a point that the liner is pressed firmly against the |
| wall install the |
| Then you can fill the entire pool as quickly as desired. |
12”
TOP RAIL 
EZ HOOK
VINYL LINER 
POOL WALL
OUTSIDE VIEW
OF POOL WALL
BEADED LINER INSTALLATION
1.Clear all sticks and sharp objects from an area near the pool, that is as large as the pool itself. Remove the liner from its carton and unfold and open the liner. Refold the liner so that it can easily be carried to the pool and unfold from the outside of the pool. Check the levelness of the sand in the pool and make sure that no sharp objects are still in the pool.
2.Install the bead receiver onto the top of the pool wall. Temporarily place
a few of the top rails over the bead receiver to support and sturdy the wall.
3.Place the liner into the pool while holding onto the top of the wall section of the liner.
4.Snap the bead of the liner into the bead receiver around the entire pool.
5.Gently pull on the liner and use a soft bristle broom to remove as many wrinkles as possible on the bottom of the pool.
6.Start filling the pool slowly with water. Continue pulling gently and working the liner with a broom as needed.
7.Some wrinkling of the liner may be evident and in no way affects the structural strength of your pool. Once the water is filled to a point that the liner is pressed firmly against the wall install the
20
