Black Box KV7021A, KV7020A manual USB computer connections

Page 16

CHAPTER 3: Installation

3.2.3CONNECTING THE COMPUTERS

USB Installation

1.Connect the ServSwitch DT Pro II’s USB cable’s (EHN7002021-0006) USB connector to the PC1 USB port on the back of the ServSwitch. Connect the cable’s VGA connector to the ServSwitch unit’s PC1 VGA connector. See Figure 3-5.

2.Connect the cable’s male VGA and USB connectors to the corresponding connectors on the back of the computer.

USB

USB, VGA, and

audio connectors on the computer

Figure 3-5. USB computer connections.

3.Repeat steps 1 and 2 for all computers.

4.Power on your computers. Your computers’ operating systems should recognize the ServSwitch and will automatically install the USB driver if it was not already installed on your computers.

NOTE

On some computers, you must enable USB support on your system BIOS. Please refer to your computer manufacturer’s manual or the motherboard manual to verify that USB support is enabled.

15

Page 15 Page 17
Image 16
Page 15 Page 17
Contents 4-Port ServSwitch DT Pro Federal Communications Commission 4-PORT Servswitch DT PRO NOM Statement Trademarks Used in this Manual Contents Specifications Hotkeys YesSpecifications Overview IntroductionOverview Components❾ ❺ ❼ ❽ ❻ ❿ ❼ ❽ ❼ ❽ ❼ ❽ ❼ ❽ What’s Included What You’ll Need to SupplyServSwitch Placement InstallationHardware Installation Installation Audio connections USB computer connections USB peripheral connections Powering Up the System Selecting Computers Using Front-Panel ButtonsSelecting Computers Using Keyboard Hotkey Commands OperationCommand Command/Description Previous PC channel. Toggle between Stop Autoscan Calling Black Box Appendix. TroubleshootingShipping and Packaging Copyright 2007. Black Box Corporation. All rights reserved
Top Page Image Contents