Kathrein UFS 705si, UFS 705sw manual Transponder Frequency

Page 61

SEARCH CHANNELS (CHANNEL SEARCH)

The  buttons allow you to select different sets of parameters for the scan.

Satellite

Use the  buttons to select the satellite on which the transponder you wish to scan is located. Make sure your reception system is aligned to the selected satellite. You can scan only one transponder at a time. If you wish to scan several transponders on a satellite, you should start an automatic scan of the transmitting satellite.

Press the  button to move to the next selection item.

Transponder Frequency

Select the transponder to be scanned, using the  buttons or the numeric keypad. At the bottom right of the screen display, the receiver shows the current signal strength and signal quality of the selected

transponder. Press the  button to move to the next selection item.

Channel Search Mode

Use the  buttons to select whether you wish to scan “only free and scrambled”, “only free” or “only scrambled” channels.

To view scrambled channels you need the appropriate CA (Conditional Access) module and a valid smart card together with a valid subscription to the relevant Pay-TV provider.

Press the  button to move to the next selection item.

Network Search

Use the  buttons (On/Off) to select whether a network search should be performed. If you set the network search to “Off”, only the factory stored transponders of the satellites you previously selected will be scanned for new as yet unlisted channels.

If you set the network search to “On”, the transponder network enables additional transponders that have not yet been stored to be located. They are then stored and scanned for new channels in the same way as the existing transponders.

When you have made your settings, use the buttons to select “Start Search” and press the button to start the search. You can cancel the search at any time by pressing the  button.

During the search you will see a display that shows you the progress of the search and the channels found so far. Newly found channels are identified with the designation “new” after the channel name.

After completion of the search, you will see the following message (example):

61

Image 61
Contents UFS 705si/705sw Disposal Instructions PrefaceUsed batteries are special waste Important Information Switching OFF the Receiver and Updating the EPGReference Note on Audio Mpeg INC. and S.I.SV.EL, S.P.A Contents Remove from the Favorites List Safety Instructions Important Notes Product Package Receiver FEATURES/SCOPE of SupplyView of Front Panel Flap Folded Down CONTROLS, Displays and ConnectionsView of Rear Panel Reception System Presets Connecting the Unit SAT-IF ConnectionsConnection and SET-UP Reception RequirementsTV and Video Recorder Connection Inserting Batteries Into the Remote ControlAudio Connection Electrical Digital Output ...  Remote ControlRemote Control RC First Installation General Here you select the TV format. Either 43 or Picture format Continue with the relevant section of First InstallationTV-SCART-Output SystemSatellite and Position First Installation DiSEqC1.0Test transponder LNB TypeFirst Installation Simple LNB First Installation Simple LNB Configure satellites First Installation Single-cable systemFirst Installation Single-cable system First Installation Single-cable system Automatic Selection user-defined First Installation Single-cable system ManualFirst Installation Single-cable system Manual First Installation Single-cable system Manual First Installation Single-cable system Manual First Installation Single-cable system Manual First Installation Single-cable system Manual First Installation Single-cable system Manual Execute Channel search Channel Search ModeNetwork Search Local time offset First Installation Channel Search/Date and TimeMenu Concept Operating InstructionsMenu Tree Main MenuAlphanumeric Inputs Language Setting OSDChannel Messages TV Channel MessagesProgramme Information ON-SCREEN Displays OSDCalling UP the Options Channel Radio Channel MessagesOption Selection Error SignallingChannel List TV/RADIO Search function Selection and sorting optionsInfo on Calling UP the EPG EPG Electronic Programme GuideSelection options Current ViewPreview View Programme Listings Categories View Search Function Additional Information i Button Programme present in the EPG Recording TimerProgramme not present in the EPG Record Daily Record OnceRecord USER-DEFINED Record WeeklySeries Recording Plan Recording Important Information Common InterfaceInserting the Smartcard and the CA Module Common Interface Videotext Teletext Selection of the LIST/CHANNELS to be Edited Edit Channel ListEditing LISTS/CHANNELS Move Channels Last Function MemoryDelete Channels Skip ChannelsCopy Channels to the Favorites List Lock ChannelsStart Blockselection Selecting Several Channels Remove from the Favorites List Edit Favorites ListsRemove from the Favorites List Rename Favorites ListStart Blockselection Highlighting Several Channels Rename Favorites ListAutomatic Channel Search Search Channels Channel SearchSatellite Manual Channel Search Transponder Frequency Channel Scan with Service ID Service ID Lock Mainmenu Parental ControlLock SET-TOP-BOX Define NEW PIN Code Settings TV Aspect Ratio TV SettingsPicture Format TV-SCART-OUTPUTVCR-SCART-OUTPUT Customize Screen MenuTelevision System Auto Dolby Digital OutputAdjust Menu on TV Display Volume BARFunctional Range Channel OSD DurationDate and Time Antenna ConfigurationCommon Interface Automatic clock changeUpdate Software Service MenuChannel List Update SoftwareRestore Factory Default Settings Recording Connecting UP the VIDEO/PVRPlayback Backup Operation Using the Front PanelTV/R button ButtonTechnical Appendix FeaturesType UFS 705si UFS 705sw Scart Socket Assignment VHS/S-VHS SwitchingConnection Example EXR 501/551/552 UAS EXR 1581/2581 EXU Short Technical Guide PID Symbol RateTransponder VIDEO-BIT-RATEGlossary Service Troubleshooting936.3206/D/0209/ZWT Technical data subject to change