VBrick Systems EtherneTV-NXG 2, EtherneTV-NXG 1 manual Set up the EtherneTV-NXG Server, NXG-1 NXG-2

V B R I C K E T H E R N E T - N X G V O D Q U I C K S T A R T G U I D E V E R S I O N 2 . 0 . 0 E

2.Set up the EtherneTV-NXG Server

1. Connect monitor, keyboard and mouse on the back of the unit, following these steps:

NXG-1

2 3 1

NXG-2

1 3 2

•If rack mounting the unit, mount the EtherneTV-NXG server in the rack, using the rack mount kit provided.

•Connect the EtherneTV-NXG server to the network by plugging the 10/100/1000 BaseT Ethernet cable into the Ethernet port 1c on the rear of the unit.

•Connect the monitor cable to the video port at the back of the EtherneTV-NXG server d. Turn the monitor on.

•Connect a mouse and keyboard to the appropriate ports at the back of the EtherneTV-NXG e

•Plug the EtherneTV-NXG server into a power source, using the power cord provided.

•Turn the EtherneTV-NXG server’s main power on by pressing the power switch at the front of the unit. f

4

•NOTE: the EtherneTV-NXG server will boot and automatically load using the default settings – this may take several minutes.

C O P Y R I G H T V B R I C K S Y S T E M S P A G E 5 J U N E 2 3 , 2 0 0 4