VBrick Systems EtherneTV-NXG 1 manual Verify EtherneTV-NXG Server Operation, Verify entries

Page 8

V B R I C K E T H E R N E T - N X G V O D Q U I C K S T A R T G U I D E

V E R S I O N 2 . 0 . 0 E

Verify entries

The previous entries will be displayed.

Review the information you entered. If everything appears to be correct, type “y” and Enter to continue. Otherwise, type “n” and repeat the setup process.

The EtherneTV-NXG server displays the configuration files it will update. Type “y” then press Enter to continue. The changes will be displayed for each of the following files. Review each, type “y” to accept, then press Enter to continue.

o /etc/sysconfig/network

o /etc/sysconfig/network-scripts o /etc/resolve.conf

o ServerName in httpd.conf

When asked if you have completed reviewing the files to be updated, type “y” then press Enter to continue.

Wait several minutes for setup to complete. A message will be displayed:

Done

Omnibase setup is complete; press enter to continue to login

Press Enter

Enter the login and password when prompted:

At the login prompt, type “root” then press Enter.

At the password prompt, type “omnibase” then press Enter.

NOTE: If you encounter an error during set-up or if the server is moved to another network you MUST perform the following operation:

Rename the setup file as follows:

￿root# mv /opt/vbricksetup/.vbrickmbase_is_setup /opt/vbricksetup/.vbrickmbase_is_not_setup

Reboot the server

root# reboot

4. Verify EtherneTV-NXG Server Operation

Verify that there is an amber link light on the EtherneTV-NXG server’s Ethernet port.

From the Linux Administrator command line: Ping the local gateway IP address.

Example: ping 172.17.1.5 (use your appropriate local gateway IP address)

From a separate PC: Ping the EtherneTV-NXG server from a PC using the EtherneTV-NXG1 IP address.

Example: ping 172.17.6.55 (use the IP address of your EtherneTV-NXG server)

C O P Y R I G H T V B R I C K S Y S T E M S

P A G E 8

J U N E 2 3 , 2 0 0 4

Image 8
Contents June 23, 2004 Trademarks CopyrightDisclaimer Table of Contents Before you Begin Quick StartUnpack the EtherneTV-NXG1 Server Set up the EtherneTV-NXG Server NXG-1 NXG-2Configure the EtherneTV-NXG Make required entries Verify EtherneTV-NXG Server Operation Verify entriesVbvodnxg1 Changing Time & Time Zone Introduction Overview System Components Procedure Version Using the EtherneTV Media ControlServerAccess the server Accessing MCS EtherneTV-MCS VersionDownload Components Watch Live BroadcastsBrowse Video Library Scheduled ProgramsBrowse and Configure EtherneTV-NXG1 System EtherneTV-NXG AdministrationHow-to Ingest content InstructionsFTP Files and File Ingestion InstructionsLicense Key Re-Installation Automatic File BackupFile Backup Cautions Reference Operation Tips