Installation Instructions | |
|
|
Concrete Installation Instructions
(Option B)
Install the wall plate as follows:
WARNING:It is the responsibility of the installer to verify that the structure to which the mount is anchored will safely support five times the combined load of all attached components and equipment.
1.Determine a suitable mounting location and lift the wall plate (10) into place (refer to “PARTS LIST” on page 3).
2.Draw a level plumb line to indicate the desired height of the mount.
3.Hold the wall plate against the concrete wall making sure the the mounting holes are level..
4.Drill four 5/16” holes into the concrete surface at the marked locations.
5.Install the four 5/16” alligator toggle anchors (120) in the holes.
6.Using four 5/16” lag bolts (80) and 5/16” washers (90), secure the wall plate to the wall.
7.Slide the latches to the outside.
6